Your cart is empty.
Your cart is empty.BUSHING KIT, CARB LINKAGE
Agent J
Reviewed in the United States on April 11, 2024
Used this for throttle linkage on my Edelbrock 1404 (same difference as 1406, etc) it fit the hole perfect and it’s just a couple bucks more than those plastic and rubber ones. Highly recommended.
Mike vickroy
Reviewed in the United States on July 9, 2022
It works great on my Holley carb
Chuck R.
Reviewed in the United States on March 24, 2022
I like fitment, I used it to connect my throttle rod to my carburetor.
Jim
Reviewed in the United States on June 10, 2021
Worth the money. Good product.
TWyckoff
Reviewed in the United States on September 3, 2020
I installed this bushing set on a Holley 3110 in order to adapt the big hole in the carburetor linkage to the mechanical throttle linkage on my 59 GMC. The bushing is of very high quality and it is made in America. I did have to mill approximately .020 off one side of the bushing in order to properly space my linkage, but that is more the fault of my linkage setup - not the bushing. The anodized finish looks nice and should provide some corrosion resistance. Good quality part.
R. Gioia
Reviewed in the United States on November 29, 2020
This product worked as advertised. Excellent quality!
Jorge Carbajal
Reviewed in Mexico on November 13, 2020
Lo use para un carburador quadrajet en un motor oldsmobile, solo usé la parte más angosta y aumenté el diámetro del cable del acelerador con un dremel para que entrara. Ya no hay juego en el pedal del acelerador y se mueve muy bien!I used it for a quadrajet carb on an oldsmobile engine, just used the narrowest part and increased the diameter of the throttle cable to fit. There is no play on the accelerator pedal and it moves very well!
Ironleg
Reviewed in Canada on July 22, 2019
Nice fit but expensive.
Skyler
Reviewed in the United States on April 16, 2019
Perfect works awesome on my eldebrock carb much better than the rubber grommet set up
RagenRat
Reviewed in the United States on July 17, 2015
Moroso 64920 Carburetor Linkage Bushing SetThese look and feel great, they fit right in the throttle lever hole on my Holley & Demon carburetors and there was no looking back.I have used other Moroso Products many times before and have been very happy with them, this one is added to one of my best. :-)Buy with confidence.RagenRat / Mark
Recommended Products
$41.95
$ 17 .99 $17.99
$32.94
$ 16 .99 $16.99