Your cart is empty.
Your cart is empty.Calcium Chloride Test Method. ASTM F 1869, Standard Test Method for Measuring Moisture Vapor Emission Rate (MVER) of Concrete Subfloor Using Anhydrous Calcium Chloride This method has and is the industry standard. Calcium Chloride Test allows you to achieve a quantitative figure which will coincide with floor manufactures requirements. Please note: The measurement obtained performing a Calcium Chloride only reflects the current condition of the concrete. Results will reflect a figure of weight in pounds of water evaporations giving off over 1000 ft2 over a 24hr period. The test must be done when the building is at the same temperature and humidity.
Jennifer Carlson
Reviewed in the United States on May 6, 2024
I returned one because it shipped expired. The replacement was also expired!
vince
Reviewed in the United States on December 1, 2024
It's been a while but it is imperative you can a test kit to test for Calcium CL for additional information prior to costly repair work or even to install a pump. Easy to use, and the results are very accurate. Just open it up, place in a open area away from equipment, activate and monitor. Send in the results and youre good as gold.
Dennis J. Menesick
Reviewed in the United States on May 18, 2022
This product is quite easy to use. Directions are very specific on how to set-up and gather results.
Edward R.
Reviewed in the United States on October 17, 2020
Havent used the test yet, but it arrived in a few days and included everything described in the kit. I will be using the test to measure the moisture in a concrete floor. Im testing to see if I can install a hardwood floor.
Jonathan Q.
Reviewed in the United States on April 6, 2018
We use these prior to pouring epoxy floor coatings in warehouses, factories, and industrial buildings where moisture can be present. These worked great.
Laura C
Reviewed in the United States on December 1, 2016
Worked great. We used this on the concrete floor before installing new flooring in our basement. Instructions were easy to follow. We did purchase a small scale in order to get an accurate measurement of the container. The dome kept a good air tight seal during the duration of the 72 hour test. I used a tool to give the adhesive an extra push to ensure a good seal. I was very happy with this easy to use, at home test kit.
Nick
Reviewed in the United States on December 1, 2015
Worked to give an accurate reading but the adhesive left residue on the concrete.
L. Kahl
Reviewed in the United States on May 2, 2012
We had to use this product to determine what kind of flooring we could when we remodel our home. The instructions are very easy to follow. Because we really wanted to make sure that the dome was air tight, we used duct tape around the perimeter of the dome over and above the gummy, sticky edge that came with the kit. We also had to purchase a small, more accurate scale to weigh the disk that absorbs the moisture. It's an easy-to-use, accurate kit and would highly recommend it to anyone concerned about what kind of flooring their slab foundation can handle.
Recommended Products
