Your cart is empty.
Your cart is empty.The MIDI Breakout Board MV board is an easy way to connect a hardware MIDI device to an Arduino, microcontroller, or embedded computer such as the Beagle Bone or RaspberryPi. This version of the MIDI BoB is a fully assemble board. The PCB provides an optically isolated MIDI I/O (Input and Output) signal and power. There are mounting also holes in the PCB for a more permanent installation. An example Arduino sketch is available on the manufacturers website which will get you up and running quickly. MIDI Breakout MV is similar to the old EZ. However, the MV includes a switch allowing you to select 5V or 3.3V levels.
solidus
Reviewed in the United States on May 11, 2021
You just need to look up the instructions online since none was provided with the kit
solidus
Reviewed in the United States on May 11, 2021
You just need to look up the instructions online since none was provided with the kit
Tom
Reviewed in the United States on March 25, 2021
Works great. They are also making a new a MIDI-IN, MIDI-OUT, with 9V regulated power with 5V, 2A to power smart LEDs, which is already to be wired to Pin7.
Tom
Reviewed in the United States on March 25, 2021
Works great. They are also making a new a MIDI-IN, MIDI-OUT, with 9V regulated power with 5V, 2A to power smart LEDs, which is already to be wired to Pin7.
Water Dog
Reviewed in the United States on April 27, 2021
Used this to use MIDI in to control things via raspberry pi. Works good. Easy to solder together.
Water Dog
Reviewed in the United States on April 27, 2021
Used this to use MIDI in to control things via raspberry pi. Works good. Easy to solder together.
Recommended Products
