Your cart is empty.
Your cart is empty.Perfect for making flat lightweight items magnetic. Magnet requires direct and full contact with steel for maximum hold, therefore it is best to make sure that magnet is flat. Magnet & adhesive work best when applied at above 60 degrees Fahrenheit or 15.56 degree Celsius. For best results: 1)Allow magnet to reach room temperature then cut magnet with heavy duty scissors or hobby knife. 2)Apply magnet's dark gray side to large metal surface for several hours to flatten curl. Do not roll magnet strip in opposite direction to remove curl. 3)Clean applicable surface for adhesive with isopropyl alcohol and allow to dry. 4)Peel back liner from the adhesive and place item on adhesive. 5)Apply adhesive to surface with firm pressure 6)Allow adhesive to cure for a minimum of 24 hours or 72 hours to reach maximum bond with surface. Magnet withstands temperatures from 0-150 degrees Fahrenheit.
Ralph Pritchard
Reviewed in Canada on December 22, 2020
I cut the magnets into 1" strips and it worked great. I sent out over 20,000 of these and nobody complained about it sticking to the fridge. Of course it doesn't stick to stainless steel or plastic but no issue as they will use tape in that case.
DO
Reviewed in the United States on July 26, 2017
Works good
Recommended Products
$24.98
$ 12 .99 $12.99
$40.89
$ 19 .99 $19.99