Your cart is empty.
Your cart is empty. Removes Studs from Engine Blocks, Exhaust Manifolds, Cylinder Heads and Other Applications.
Allows for easy removal of studs. Tool has two holes, 1/2" (14mm) and 3/4" (19mm) for optimum fit, minimizing damage to threads. Range 3/8(10mm) - 3/4(19mm). Design allows tool to grip flush with mounting surface of the stud so it can grab studs that are broken off very close to the mounting surface. Use with 1/2" square drive.
David Brown
Reviewed in the United States on January 15, 2025
I successfully extracted two studs from an older engine the day of receiving this product, before the tool EXPLODED! Scratched a fender. Do NOT purchase this if you plan to encounter studs with any rust or corrosion; the cheap metal will burst. 1/5 rating. Sad
Hot rod
Reviewed in the United States on September 16, 2024
worked well.
Amir
Reviewed in Canada on August 9, 2024
Good tool
Customer
Reviewed in the United States on July 13, 2024
I used this to pull studs from a steering arm assembly and it worked very well.
Wowy 61
Reviewed in the United States on December 20, 2024
This is just a great tool for removing studs that are broken (no head) but with an accessible piece of shaft. This tool will grip and remove the stud.
Dngr Brthr
Reviewed in the United States on December 1, 2024
Works great for pulling studs out of the exhaust manifold out of a 5.3 Silverado
Mike MacPherson
Reviewed in Canada on November 2, 2024
Product would work well for a full length stud or at least 3/4" in length. I attempted to remove what was left if a broken 14mm bolt and tool exploded from the leverage available. If the bolt was longer than 1/2" I feel it would have worked. Wear your eye protection.
jewel3ca
Reviewed in Canada on July 18, 2023
Bought this for a totally different purpose.Need to torque test welded studs to destruction, at my workplaceIt is able to grip, squeeze, and hold tight to over 300Nm torque.Will buy again if this breaks.
Yves R Desrosiers
Reviewed in Canada on March 19, 2023
Though a bit large but it work like a charm getting that stubborn stud out.
12-Volt Man
Reviewed in the United States on January 25, 2023
One of the best-designed stud pullers around. Quality steel and sturdily made. Best for use on longer studs where the knurled wheel that does the clamping doesn't impact the threaded ends of the stud, but this puller and some Kroil usually makes short work out of pulling just about any stud you can fit it around.
Robert Molina
Reviewed in the United States on July 2, 2022
I busted a couple of seized bolts that go into my engine block. Luckily, I found this tool on a Friday and received on Saturday. It grabbed on to the piece of bolt shaft and removed the broken bolts like they were nothing. 100% would recommend this!
Zehma
Reviewed in the United Kingdom on June 6, 2022
It's okay, but if you have to put significant force through it to extract a stud, the stud is liable to be jammed by the cammed wheel, necessitating disassembly by drifting the camming wheel out of the body.
herbsta8
Reviewed in the United States on July 7, 2012
"Made in Taiwan" printed on the item with nothing on the packaging to say it was made to Lisle`s specifications.
Recommended Products
