Your cart is empty.
Your cart is empty.Product Description
We have our own factory, which can offer ODM & OEM service. The main series:
- PIPE FITTINGS
- HOSE BARB FITTINGS
- 45°FLARE FITTINGS
- COMPRESSION FITTINGS
- PUSH-IN FITTINGS
- DOT AIR BRAKE FITTINGS
Legines 45 Degree Street Elbow
1/4" NPT Male x 1/4" NPT Female Brass
- 45-degree street elbow for connecting a male-ended and a female-ended pipe at an angle.
- 1/4" Female National Pipe Taper (NPT) threads on one end and 1/4" male NPT threads on the other for connecting pipes with different ends.
- Material : CA360 / CA377
- Note : Not allowed by federal law to be installed for potable water use in the U.S.A.
45-degree street elbow
Durable solid brass
Brass barstock design
Heavy duty and Clean threads
Parameters
Select the suitable size product according to the marked parameters
Pipe Fittings Series
Our factory has more models for you to choose from.
Remick C.
Reviewed in Canada on February 18, 2025
worked good as it should.
Tom Sendelbeck
Reviewed in the United States on January 21, 2025
The threads were cut well. The quality looks good. I put them on a fuel line application. No leaks.
Phreich
Reviewed in the United States on July 8, 2024
I built an outlet manifold for supplying air at the front of my shop/garage, and this allowed me to kick the industrial coupler that was attached to the vertical tee on the pipe that came down from the filter that started out the manifold out at the same 45 degree downward angle to match the rest of the tees that were mounted horizontally from that initial tee.I wanted the couplers to be easier to attach to than if they would be if they were mounted pointing straight down, but didn't want them coming out at a 90 from the wall as that would cause undue stress on the couplers and hoses that would be attached to them. A 45 degree downward angle seemed just right, and this fitting allowed me to do that on the one tee that was mounted vertically that started off the manifold.
J. Harris
Reviewed in the United States on July 24, 2024
Greetings. These were used to reconfigure a propane manifold so that two separate propane regulator and hose sets can be operated from the same propane tank at the same time. These fittings appear to be made from brass bar stock, though that is not explicitly stated in the description. The fittings are properly machined and worked very well. The square bar stock surfaces gave a great place to place a wrench to tighten them into place. The threading was smooth with no burrs or rough surfaces. These parts worked well.
Steve
Reviewed in the United States on December 7, 2024
used to offset an oil pressure sending unit on a 34 Ford. problem solved and happy with the results
Jason Niemier
Reviewed in the United States on November 16, 2024
Works as expected perfectly.
Salvador Torres Jr.
Reviewed in the United States on November 1, 2024
these are hard to find parts, they worked well and hope they bring me years of use.
John P
Reviewed in the United States on October 24, 2024
Good quality and fit.
Ralph Lindsey
Reviewed in the United States on April 25, 2024
The fitting was great but me being a dummy I didn't know the difference between a steet thread and a compression thread
Michel Piette
Reviewed in Canada on April 20, 2024
de bonne qualité merci !
Recommended Products