Your cart is empty.
Your cart is empty. Weatherproof junction boxes, perfect for use outdoors.
junction box means these are well protected from rain and water splash back,making them perfect for joining wires inside.
The electrical junction box is easy to operate and repair, no cable cutting, more convenient.
Suitable for indoor and outdoor electrical ,communications.
Easy to install and easy to use.
Customer
Reviewed in Canada on March 7, 2025
Very good quality. Wish I would have known about these sooner.
P.C.
Reviewed in Canada on January 1, 2025
Used this for extending my speaker cabinet options for my amp.
WilliamG
Reviewed in the United States on September 6, 2024
Good quality, I plan to use one on a piece of equipment which will be exposed to the elements 24/7. Time will tell.
Customer
Reviewed in the United Kingdom on July 6, 2024
Stainless screws in brass bushes, sealing strip easy to fit after carefully trimming to length. Robust plastic, suitable for use outdoors. Quite tricky to cut as it melts very easily; don't use an electric saw. Must be drilled slowly, too. Mine houses electronics on a motor-boat.
JEBates
Reviewed in the United States on July 31, 2024
used this to house a small ESP-based microcontroller and relay for a lighting project. gasket fits well and makes a solid seal. i drilled a hole to accommodate some wiring though and it was easy enough to drill with a standard bit. be aware the inner dimensions are not perfectly rectangular due to the screw holes in each corner. sturdy, solid construction.
K ROMERO
Reviewed in Mexico on June 5, 2024
Le quite una estrella porque están muy caras, pero la calidad esta buena.
J. Carter
Reviewed in the United States on May 25, 2024
I’m using these for outdoor work boxes for low voltage switches. The boxes are sealed and use a gasket under the front plate. The mounting holes are through the edge of the box and do not allow water in.All that’s necessary to mount switches and wire glands is a step bit.The box is well made and available in several different sizes. The only improvement to the design would be a slightly larger opening for the mounting holes. I needed to use special small head finishing screws to mount the boxes.
David pease
Reviewed in the United States on December 5, 2024
Worked great as a atv dashboard
George Kaiser
Reviewed in the United States on December 21, 2024
GOOD QUALITY WITH SEAL
John Hoffman
Reviewed in Canada on December 1, 2024
Too small for what I needed but it’s a solid box for your project.
Calvert Sproul
Reviewed in the United States on October 30, 2024
I used this project box to enclose and mount a 3-3/8" digital GPS gauge on an older UTV. The exterior finish, quality and stainless hardware are perfect for the application. Highly recommend!
Truthsayer
Reviewed in the United States on November 12, 2023
I'd take off 1/2 Star since you have to install the gasket and it isn't a continuous gasket, but the box is sturdy for being plastic, has stainless screws, and is offered at a decent price. I will buy more. I'm using one box to mount a buck converter, on/off switch, and 9vdc power jack with a battery converter mounted on top for a Milwaukee Fuel battery. It provides ample, clean power for guitar pedals. The batteries last many gigs before needing a recharge, it's easy to carry a spare battery and it eliminates searching for a 117vac outlet, ground loops and having another power cord on the stage. Use a daisy chain, plug and play, excellent clean power and far less expensive than the regulated, filtered power supplies they try to sell you. FYI, you can do the same with a DeWalt battery adapter, or any other. You'll need this box, the battery adapter (they come with on/off switches and fuses), a buck converter and a DC out jack. Tools; a drill and bits, screws to mount the battery adapter, a soldering iron with solder, and a multi-meter to set the buck converter voltage. Not difficult to do.
Recommended Products
$22.96
$ 10 .99 $10.99