Your cart is empty.
Your cart is empty.Advanced die geometry, allows for faster cutting! This hexagon die is made of high carbon steel for cutting of external threads by hand. The die size is etched on the surface for easy identification. The first number represents the diameter of the machine screw die; the second number is the distance between the threads per inch. It's best suited for maintenance and repair work. Ideal for the areas with limited space, just use a wrench or socket!.
Gerry
Reviewed in the United States on September 9, 2024
Die worked well like advertised
Mike
Reviewed in the United States on July 31, 2024
Received a "Hanson" die, not an Irwin. I was in the middle of a job and went ahead using it to clean up a few exhaust studs. As you can see, it suffered several chipped flutes, and I wasn't hard on it or using an impact, this isnt my first rodeo.Buyer beware.
jnaka16
Reviewed in the United States on July 28, 2024
Works as it’s supposed to. Purchased to replace a name brand die that I received in a kit. The said die was marked wrong and I was left without the one die that I needed to repair the threads on a specific eye bolt.
Chris Basulto
Reviewed in the United States on March 23, 2024
This was a replacement of one in my set but it works as advertised. Keep oils when cutting for best results
Anon
Reviewed in the United States on December 4, 2024
Made in USA. Cuts threads nicely and isnof very good quality. When it comes to cutting threads, dont cut corners buy purchasing lower quality knock offs. These work great. Great price too.
Customer
Reviewed in the United States on January 20, 2024
Needed a 4" 10mm bolt threaded all the way. Prior to ordering I was leery based on all the negative reviews, but couldn't find any mfr with as good of reviews.. Packaged as photo indicates - Hanson must be a subsidiary of Irwin. Used small amount of motor oil and took my time, reversing direction to clean the threads every revolution and was able to cut 2.5in of 10x1.5 threads in 10mm Grade 10.9 bolt (a high strength bolt). Used 1" deep impact socket with driver on lowest setting, and a 14" adjustable wrench. It was slow going. If you don't reverse the direction to remove cuttings it will bind and break the die.
Jackofalltrades
Reviewed in the United States on October 9, 2023
Seemed to be of good quality, chased the threads with ease
S. Lipsey
Reviewed in the United States on June 7, 2021
Right item. On time
Recommended Products
