Your cart is empty.
Your cart is empty.For isolated sites, power-restricted areas, the Hunter Node is the smart, reliable solution. The Node mounts to a valve's solenoid quickly and easily and without screws, drills or additional wires. The unit's solid construction and waterproof exterior ensure it can handle the harsh environment of a valve box.
Martin
Reviewed in the United States on September 25, 2024
Installs and Programs easily. Great for a single station application. Runs up to two years off of two 9 volt batteries so no low voltage to wire to it. Works perfectly!
Customer
Reviewed in the United States on August 30, 2024
Not easy or intuitive to program. Pain in the rear.
Robert L.
Reviewed in the United States on July 7, 2024
Our old controller had been hit by a lawnmower at least once, so when I attempted ti make adjustments it was impossible. I ordered the new one, installed it, and it works great!n
CP
Reviewed in Spain on July 24, 2024
O programador funciona bem e é robusto
nk
Reviewed in the United States on July 10, 2024
It was a great DIY. The instructions were clear, and I was able to remove the old one and replace it with this new one in 20 minutes.
Cory
Reviewed in the United States on May 12, 2024
I like that it works well once it's programmed.However, the user interface is the absolute worst I have ever encountered, so getting it programmed each spring is a hit-and-miss, trial-and-error exercise that usually spans several days of tweaks to see if the thing is working as expected.Six buttons control the programming for the horrendously complicated sequence of non-intuitive button-pushing to set zones, times, programs, start times, manual watering, overrides, various kinds of repeats, and a whole host of other great features. However, all these features come at the expense of mind-numbing programming complexity that makes little logical sense and makes the entire unit with something that's more intuitive and user-friendly.As I mentioned, I hate this thing.
J. McMillan
Reviewed in the United States on October 14, 2024
Had to install this on a valve not connected to the grid. Was quick and easy. I did have to swap the valve to a hunter one. I could have cut the wires and used the other brands old valve, but wanted to leave them factory sealed. Comes with a mount plate/holder and dust cover.
wendy Lee
Reviewed in Canada on April 4, 2024
this works well for our needs in the irragation department
JD Press
Reviewed in the United States on August 9, 2023
I purchased this Hunter sprinkler controller to replace an older unit that had failed after many years of use. This new replacement controller came with a prewired solenoid as an extra surprise that also replaced the existing solenoid. Installation, consisting of replacing the solenoid, took less than ten minutes. The new controller uses two 9 volt batteries for power in contrast to the old Hunter unit that only used one 9 volt battery. I had to replace the old unit battery about every six to nine months so I am hopeful the new controller will operate for a longer period of time without having to replace the batteries. Programming was identical to the old unit and took me about 15 minutes to program the new Hunter. Maybe it was due to the age of the older unit but the new Hunter controller display was much easier to read and see items displayed. It has operated flawlessly and continuously for two months since it was installed. I will change the programming later in the late fall season and check the battery level at that time. This is a great battery operated sprinkler controller and works very well where you do not have any 110 Volt power source. I find it easier to program than my wired power sprinkler controllers and just as reliable. Do not forget to turn off the water source before removing the old solenoid and controller...........
Kunde
Reviewed in Germany on August 16, 2023
Meine 10 Jahre alte Bewässerungsanlage funktioniert wieder zuverlässig. Die Magnetspule passt auch auf das alte Ventil, somit war die Reparatur in wenigen Minuten abgeschlossen.
The sprinkler guy
Reviewed in Canada on August 12, 2023
Used this product and works perfect.
MICOL CLAUDE
Reviewed in France on April 11, 2022
En cours d'installation.
Lisa
Reviewed in the United States on October 21, 2017
We live at a place where we have a HOA breathing down our necks at all times. One day we noticed that our in-ground irrigation system went off on a day that it shouldn't. Our HOA puts pressure in the lines only on certain days and sometimes as they test our sprinkler systems by putting pressure in the lines on a day that there shouldn't normally be pressure. If your sprinkler system goes off on that test day, they'll fine you.Once I popped the old NODE100 out of the ground I noticed that the display had water bubbles in it. If I tried to wake it up, it would respond incredibly slowly. Then, if I tested it, it would completely "crash" and would not respond to any inputs; I had to remove both 9 volts and replace them to get it to boot up again. At this point I knew that the water proof seal of the timer had been purged and it was shorting it out. The circuit board is completely potted and is not accessible without destroying it. I had no choice other than to replace it.I shut off the line by twisting the solenoid shut and ordered this timer as an exact replacement. It took a while to arrive but, it was well worth the wait. I set the timer to run for 30 minutes even through our HOA puts pressure in the lines for an hour. This is so my daughter can make it to the bus in the morning without getting drenched.This sprinkler timer has been working great for a couple months now. Its a little confusing to set up because, you can customize a lot about how it works. However, Hunter has a series of YouTube videos that will help you set up every aspect of this timer to how you want. Expect to have to check the batteries every year and expect the water proof seal to break after a couple years, however.
Recommended Products
$112.84
$ 49 .99 $49.99
$280.46
$ 99 .00 $99.00