Your cart is empty.
Your cart is empty. 1/4-20 Thread D-ring stainless steel camera screw
Material: Screw: Stainless steel, D-ring: Zinc alloy
Screw shaft length: Approx.17mm
Threaded length: Approx. 12mm
No thread length: Approx.5mm
D-ring outer diameter: Approx.16mm
Uses: Used to connect various models of DV, DC, camera and some camera tripod quick release board.
Note: manual measurement, there is a small reasonable error range
Package Included:
2pcs 1/4 inch D-ring stainless steel camera screw
Debra Stamp
Reviewed in the United States on January 6, 2025
Returning because the screw base was too long, but they are well made and of good quality.
Dirty Bird
Reviewed in the United States on January 15, 2025
UPDATED REVIEW AFTER REPLACEMENT - The replacement D-ring adapter was the correct 3/8" & will work well for my needs. I had to drill out the extra quick-mount plate on my economy tripod to accommodate the larger adapter. Also note these are listed as 3/8" x 16mm. 16 mm is the total length of the adapter. The useable thread depth is 10mm. Regardless they will get the job done.ORIGINAL REVIEW - These may be a fine product, but the seller packed & shipped 1/4" x 16 adapters in packaging clearly labeled as 3/8" x 16. Now I have to return them, delaying my project.
Manuel M.
Reviewed in the United States on January 13, 2025
Excellent material and grip for any equipment, I use it in photography and it has fit quite well in my accessories as a support for my extra screen.
jim chemsak
Reviewed in the United States on September 16, 2024
Fits snugly, clean machine work done on them.
courtney warren
Reviewed in the United States on June 4, 2024
Works great on my Swarovski Spotting scope
Douglas Chin
Reviewed in the United States on June 17, 2024
I bought these to fully take advantage of the deep holes in a spotting scope and prevent it from falling off a tripod when my wife carries it long distances over her shoulder. The original tripod screw would work loose and almost detach before she noticed it. These are high quality and are exactly as described and pictured. Note that the non-threaded part is 5.5mm in length which matches many other screws but this dimension wasn't included in the dimensioned drawing. The screws are mildly attracted to magnets the way some stainless steels are so I think they are actually stainless.
Joseph/Nicci
Reviewed in the United States on July 28, 2023
The D-ring on one of the screws is so stiff that I can't move it, but the other one is fine. The most important thing is they fit the tripod mount on my camera, and I only needed one anyway, so I'm not too bothered by the fact that I can only use one of the two screws that came in the pack.
Monique gaines
Reviewed in the United States on December 30, 2022
These were to long for my tripod so I was not able to use them
Recommended Products
