Your cart is empty.
Your cart is empty.Bronze/aluminum alloy cones, rubber surrounds, cosmetic steel frames, and shielded motor structures are the distinguishing features of the HiVi B Series full-range speakers.
ズー
Reviewed in Japan on August 7, 2024
値段と見た目で購入したが個人的に感激する音は出てこない音は出ます
sumika
Reviewed in Japan on June 16, 2022
今迄、P800Kで聞いていたのであるが、高域が足らない感じで、他のスピーカーからのバランスも悪い感じがしていた。簡単に言えばP800Kが浮いているのだ。どうすれば良いのかを考えて思いついたのが、B3Nである。過去にも買った事があるので、再び挑戦してみたのだ。その試みは大正解であった。バイオリンは、BGM的に一日中聴ける感じとなった。更に私の好きなケニーGの曲も生きている様な心地良い響きを感じさせてくれる。私のシステムが180度変わった素晴らしい感じとなったのである。感謝です。ありがとうございました。因みに、PT20Kとの相性も最高ですね。
Mutin
Reviewed in Japan on February 20, 2021
密閉型で箱を作りたかったので探し回りました。 他の方のレビューを見る際にこれだけは押さえておいてください。このスピーカーの特徴は、Qesが1.07もあるということです。これだけの数値があるこのサイズのスピーカーは、なかなか見つかりません。この数値は密閉型で箱が作れるということなのです。これをバックロードやフロントバスレフに入れたら低音がドカドカで聴けたものではないです。Qesが低くて良いのであれば、フォステックスをはじめとしていくらでもあります。 スペックから考えれば、Fsが77Hzで、Qesが1.07ですから、これはもう密閉型専用スピーーカーといって良いでしょう。このスペックを実現するために、結果的に能率は81dBとかなり低め。さらに許容電力が15Wしかありませんから、卓上のニアフィールドで使うしか無い。取扱説明書には、等価容積Vasは、2リットルと書いてあります。 説明の図が鮮明ではないので、実測を書いておきますと、外径φ90、穴径φ71、取り付けは、PCD83でφ3.5が90°振り分けです(2023年10月31日訂正)。それで、MDF9mmで箱を組み立てて聞いてみました。ボーカルものは、声が生々しい。よく唾をかけられているなどと表現する方もいますが、クレモンティーヌはそういう感じです。低音は、ベースは少し引っ込みぎみですが、よく締まった指のタッチがわかるいい音です。これが狙いだったので、ちょっと嬉しかった。ヘッドフォンで聴くと低音がとても締まって聴こえますが、あの感じです。余計なことだったのですが、ギターのミスタッチもよくわかる。まだちょっとキンキンいうようなところがあり、チューニングと慣らしが必要そうです。 箱は前面の面積が小さくなるようにし、内容積は等価容積と同じ2Lとしました。吸音材は、聴きながら調整しましたが、結果的に全部抜きました。 バックロードやバスレフの低音には、辟易していました。ただ、低音が出ているというだけで、どかどかボコボコです。スピーカーから直接聴こえる低音と、バスレフなどの開口部から出る音は全く別物で、それが合わさって何とも嫌な音になる。現在、消去法で選んだ TANNOY Reveal 402 を使っていますが、前面開口バスレフなのでこのことはずっと気になっていました。 このスピーカーでようやく嫌な低音から解放されるかもしれません。 アンプ側は、低域をイコライザで3dBアップしています。これで、オーケストラのコントラバスが他の楽器と同列に並びました。 ちなみに、試聴用には様々な音源を使いますが、良く聴く音楽はクラシック、それもバッハのみです。 クラシックも聴けるスピーカーですが、トランペットはかなり耳に突き刺さります。トランペットはコンサートでもホーン真正面の席だと突き刺さりますので、違和感があるほどではありません。どちらかというとポップス向きです。
まつもと
Reviewed in Japan on March 20, 2019
自分の持っているアンプの質がもう一つなのかもしれませんが、高温がきつく聞こえてしまい、疲れます。アンプが2020を使用してはいるが、激安のものなので、ひずみが聞こえてしまうのかもしれません。他の8cmユニットに変えました。
vivi
Reviewed in Japan on May 29, 2017
とりあえず、小さなスピーカーシテスムを自作してみようと思い色々と検討しました。このような場合は大抵フォステクス製品から入るんだけれど、ちょっと変化球で行きたいなと思い、センターキャップの無いお椀型のこのルックスのHivi/B3Nが目に留まりました。なんか、DALIとかFLACっぽい雰囲気にヤラれてしまいました。まずは外観、次に値段の安さで気に入ってしまったのですが、ネットで検索してみるとかなり好評なんですね。キャビネットは、WYVERNの「【2本1組 スピーカーボックス】木製 ユニット:3インチ~3.5インチのユニット対応 H20cm×W12cm×D13cmのコンパクトサイズ! 【スピーカーターミナル(金属製ジャック)×2個付属】 Cセット」なる物と組み合わせました。これは半完成状態のキットで仕上げ済み、網も付いて2本セット3,780円とお買い得なので決めました。嬉しい事に、このキャビネットの穴はHiVi/B3Nにピッタリ(配線部は干渉するが)、ごく僅かな加工だけで使えます。ユニットを止めるビスは、ネジ穴に対してM4だと少々キツイので少し小さめの3.5mm位が最適です。音質に関しては、元々8cmサイズのユニット馴染みが無いので当初はこんな物かとか思っていましたが、吸音材その他の手直しと慣らし運転が進むにつれて、結構良い感じに聞こえます。低い音も、高い音も、かなり素直に出て来るんですね。外観ルックスに関しては、安い筈なのに高級感があったりするのです。スピーカーは値段が高い程良い音がする原則があると思っていますが、この製品はちょっとお値段以上の結果が得られるなと思いました。安いんだから、気になったらとりあえず買っておくと良いですよ。
DNT93
Reviewed in the United States on March 1, 2017
I love these guys. I ordered two for a DIY Computer soundbar build. They good at first but they should really be used with an equalizer. I pushed the bass and 2k to 5k hertz ranges and it made the drivers sound much better. For my application they were great. Hivi even included foam rings for mounting the drivers to eliminate vibrations. Great drivers that I'd recommend to anyone.
NorCalMod
Reviewed in the United States on February 24, 2017
In a small sealed enclosure, this speaker is a phoenomenal performer and has become a standard go-to. It's hard to beat in so many ways... aesthetcs, performance, price... the /only/ downside is that the outter rim is a bit thin for a #6 screw and the hole is too big for a #4... so screws look a bit oversized. Ideally, the rim would (1) be 1mm wider, and the hole would be 0.25mm smaller... even better, the rim would be solid/flat like it's "square-faced" sister speaker. With the turned edge design, the spcing has to be just right (and currently, it's a bit off).Note: I did /not/ receive a promotional discount for a positive review... (but if someone ever wanted to hit me up, you know where to find me)... ;)
JF
Reviewed in the United States on January 16, 2016
All in all for the money, it seems to be a decent speaker so far. Definitely needs to be hooked up to an amplifier with an adjustable equalizer though to really bring out its sound capabilities. Also to make nkte, if youre wondering about the dimensions of this speaker, no offense to the other reviewer, could have been a typo. But this speaker is NOT 6.5 inches in diameter. It is exactly 3.5 inches in diameter (measuring the outer metal ring) and 2 and 5/16 inches high
Lance x.
Reviewed in the United States on August 27, 2015
Bought these to replace some older, starting to wear out mids in the Klipsch 2.1 promedia speaker system. I knew going in that I would have to modify them a little bit to get them to fit, but after drilling the holes a little bigger and moving the crossover a little, they fit fine and sound even better! I'm looking to replace the tweeters next but haven't found one to fit yet. Very happy with this purchase and brought new life to my already awesome 2.1 setup!
Patrick L Davis
Reviewed in the United States on January 17, 2014
installed in a 5x9 x7.5 deep sealed enclosure and the sound is crisp and clean, but too crisp in the higher range. I added a notch filter to tame down the shoutiness and it is much better. Can't push heavy bass tracks very loud when connected to lepai2020A+ amp or distortion occurs. But for lighter music it is wonderful!
A. Fonteijn
Reviewed in the United States on May 8, 2012
Bought these drivers to make my own computer speakers. Currently they are directly connected to the amp without any filter and they already sound very decent. I'm looking forward to making a filter to get rid of the 8khz spike that the drivers produce. Obviously, these drivers won't produce a lot of bass and they would probably sound best in combination with a woofer or sub-woofer.
Doc
Reviewed in the United States on March 12, 2012
I bought these for my first speaker building project. I am by no means an audiophile, but I love music. I appreciate the ability to listen to music at elevated volumes with very little/ no distortion. My basis for a comparison is my JVC TH-C50 surround, which is a nice mediocre system. I put the HiVi B3N speakers in two .17 cubic foot ported enclosures built with .5 inch MDF. These speakers are on par with the JVC speakers and the cost of the JVC system was more than $300. Granted, if I had put these in a 2way or 3way system, I would've had better results. The speakers provide clear highs and mids while going into the lower frequencies with ease. Do not expect these to pound out bass, but without the suggested filter (Google 'Zaph Audio HiVi B3S'), I can't ask for more.Pros: Good frequency response throughout, small size, low power, great valueCons: Require a large ported enclosure for good bass response
mcd113
Reviewed in the United States on February 18, 2011
Purchased to use with acoustimass 7 given as a gift.Had only one double cube to go with the base, so purchased two of the hivi, used with an "open-baffle" cabinet (simply a painted black particle board with hole cut into it) and tried it out.The sound is very good. I'm no audiophile, but this sounds nearly as good as the double cube bose when standing in front and trying to compare.The company and product were outstanding. Definitely would buy again.And if you have the desire, and a little time to research, likely could make a very good surround setup for a budget.Good luck.
Recommended Products