Your cart is empty.
Your cart is empty.These decoders can only solve the foglight flicker problem.
John B.
Reviewed in the United States on June 8, 2021
Easy to install. Important to have your +/- polarity correct. If your lights throw errors, change polarity amd re-test.
Ken
Reviewed in the United States on January 3, 2021
The led bulbs are very bright and good quality and with the polarity correct they are a plug and play
Georgios
Reviewed in Canada on September 6, 2020
Didn't need to use it. It was a little bulky overall but it was cheap so no complaints. Returned it because I had no need for it since the lights I ordered Canbus errors built into them.
Trevor
Reviewed in Canada on July 23, 2020
Did nothing on 2013 jeep wrangler rubicon or a 2012 Jetta TDI.Good luck.
M Lopez
Reviewed in Canada on December 26, 2020
Installed on a 2009 BMW 323i, and it did not work. It still triggers the CAN-bus error on the dash which shows a light bulb icon. Purchased with the expectation that it would handle the CANBUS bullshyt as advertised, buy it failed in this regard. DO NOT RECOMMEND FOR CANBUS CARS.
Peter Mustapic
Reviewed in Canada on December 2, 2020
They are okay. Just installed them and they had been sitting brand new In a box and 1 is defective.
batman_77
Reviewed in the United States on November 1, 2020
Very intuitive and easy to install, they work great to get rid of the parking light out, canbus error on my led headlights on my ram truck
Luis Riffo
Reviewed in the United States on January 16, 2020
I bought a h7 led hikari set to update the factory halogens, in advance I already knew I had a canbus system since I had tried with others. After installing the lights first I tried and everything ok, and he indicated the burned light signal, so install the hikari canbus, and the signal did not disappear, which for its weight and quality not if it carried something inside, therefore Now I have a led kit that gives me error and a canbus that does not work. In my case, the lights didn't blink before, so I don't know if it works in that case either.
Auzzy
Reviewed in the United States on September 25, 2019
I got just in case I needed and I did. Works great on my 2014 Mercedes c300. I love having led beams in my projectors.
R. Polakowski
Reviewed in the United States on August 20, 2019
Put in a 2013 Audi. Was a little tight, but managed to fit. Went from barely being able to see the road to HID-like headlights. Totally worth it. What's not worth it - don't buy the "trim" rings. They were a direct fit for H7s.
Moody
Reviewed in Canada on December 4, 2019
Plugged these online with some Hikari LED headlights and no flickering and function as stated.
S
Reviewed in the United States on May 4, 2018
Worked ok but was bulky so I wan't able to make this work. The connectors on one end are snug but the plug side can come loose. They should be able to address this and the ballast in one unit.
Hayden S.
Reviewed in the United States on December 17, 2018
I recently installed Hikari LED bulbs in my 2010 Volkswagen Passat. I knew I needed these so I ordered them at the same time as the bulbs. I tested without these at first, every few minutes the car would throw an error saying the bulb was dead (as expected). The light did not actually go out or ever flicker.After testing, I installed the LED Conversion Kit Headlight Canbus Resistors and I thought they were working great. That is until I hit the highway. The error started to pop up again but only for the front left dipped beam. It doesn't happen right away or on a consistent schedule but happens at least two to four times on my way to work (about a 25-minute drive).I love the look of the LED lights but don't want to deal with dash lights coming on. Debating if I want to return just the resistor or return everything and look at something else.
Recommended Products
