Your cart is empty.
Your cart is empty.Made of high tensile cast iron properly seasoned against distortion. Clamping slots are widely used for machining, layout and inspection. Accurately machined and Ground square and parallel on outside and ends.
Julian W
Reviewed in Canada on January 26, 2025
This is great little clamping block for my table. It’s square with a well-surfaced flat clamping face.
Jerry Blankenship
Reviewed in the United States on September 18, 2024
Very good
Bruce Hille
Reviewed in the United States on June 28, 2024
Not for heavy duty applications but works well for light machining operations. Plan on spending some time deburring it, as it has sharp enough edges to draw blood.
WhyIsThisSharedPublicly
Reviewed in the United States on December 29, 2024
Well packaged and protected. Square. Sized as advertised. Should work out nicely.
Rick Mann
Reviewed in the United States on October 7, 2024
I'm not a super-experienced machinist, but I would've expected this to be as square as my tools could show. Unfortunately, it's ever-so-slightly not square.
Louise Watts
Reviewed in the United States on January 11, 2024
I ordered this angle plate to use on my mill. Upon inspection of the product, the machining on the faces is pretty good for imported items. The mounting slots are equally spaced and finished ok for home hobby use. However, the web casting on the back is not equally spaced from the ends which causes one mounting slot to be useless for securing the work. This should have been rejected when taken out of the mold. It is that obvious. Lack of quality control. I returned the item and reordered. I have used this importer's products and they have all been fine. This was probably just a fluke thing from the factory.
John Short
Reviewed in Canada on August 15, 2023
This angle plate is great for a smaller mill. Square, descent weight and clean. I should buy another one.
Mario c.
Reviewed in Mexico on December 20, 2023
Producto de calidad
GD
Reviewed in the United States on March 11, 2021
Packaged ok, no rust. 90 degrees close enough for my home use. I was able to file in one edge to be able to stand block on it and be 90 degrees to the two larger faces. Razor sharp edges all around require chamfering, but with that said still a good value
Randy Frattinger
Reviewed in Canada on September 2, 2020
The part was of good quality for the price.Disappointed that the part had a lot of sharp edges that when handling it one could get cut.
Laisilie
Reviewed in the United Kingdom on March 17, 2019
This is a very sturdy angle plate. It is accurate on the angle and just what I needed to support the milling attachment for my metal turning lathe.
Customer
Reviewed in the United States on March 15, 2019
Angle plate works great. The plate is surprisingly light for iron, it must be some light weight cast iron so don't know how strong it would be. I would not use it for anything that would take a large shock load like hammering or banging around on it. I checked it with a machinist square and it was right on. Slotted holes spacing fit the T-slots in my Bridgeport. Overall works great for what I do with it.
Tim F
Reviewed in the United States on July 16, 2015
Great bargain for a fixturing plate. It's soft enough to add tapped holes easily, but still a pretty nicely ground finish and for half the cost of the same thing at MSC, etc al. These are cast iron, and soft enough to deform a little from handling. I had to file off a high spot to get it sitting perfectly on granite after it was set down hard on one of its corners, but that's just cast iron.
Recommended Products
