Your cart is empty.
Your cart is empty.David W.
Reviewed in the United States on February 11, 2025
Works great and ease to install with.
Kero
Reviewed in the United States on December 30, 2024
I recently used the BLEKOO 2 Pack Cabinet Clamps for a kitchen renovation project, and they were a game changer. These clamps are solidly built and provide a secure hold, making cabinet installation much easier and more precise. The pilot hole guide is a great feature, ensuring accurate drilling every time. The clamps are easy to adjust and hold the cabinets firmly in place while I work. The blue color is a nice touch, making them easy to spot in my toolbox. If you're looking for reliable and efficient cabinet clamps, I highly recommend this set. They made my installation process smooth and hassle-free
Jeff Scott
Reviewed in the United States on December 15, 2024
This is a decent set of face frame clamps that could have been a lot better. They come with self adhesive pads for the jaws and face of the clamps to protect against marring and do a great job of holding face frames tight and flush while freeing up your hands to predrill. My only complaint is the drill guides don't swing out of the way so you can run a screw into the hole you just drilled. You would have to remove the clamp to do this, which would defeat the purpose of these clamps or loosen the screws that hold the drill guide in place. There is no detent to re-center the drill guide either like on my other set of face frame clamps. A simple feature omitted on these took them from a 5 star product to a two star product.
D. Russell
Reviewed in the United States on December 1, 2024
These are great for attaching cabinets together. They clamp them together and also flush up the face frames. It's helpful to barely loosely snug up the side clamps before tightening the front clamp. Otherwise, there's too much friction to align them together. My only complaints are 1) the screws are super smooth but I expect that will come in time and 2) the drill bushing don't lock into place. You have to be careful to position it just right or the installation screws won't fit through the clamp.
Ray
Reviewed in the United States on November 9, 2024
These cabinet clamps are specifically designed to align the face frames of two cabinets, securing them flat and straight while drilling pilot holes for screws. I tested them on some scrap wood, and they seem well-suited for ensuring accurate alignment. The clamps grip at three points: the front face and both sides, keeping the face frames flush and stable, so I can drill centered pilot holes with confidence.These are built with solid steel parts and feel very sturdy. The built-in drill guide is a helpful feature, and the adhesive pads on the alignment plate prevent scratching the cabinet finish. While they work well for aligning face frames, they're a bit specialized; they’ll likely spend some time in the specialty clamp drawer between projects if you don't work with cabinets often. For frequent cabinet installers, though, these could be a great addition—but you may need more than two if you're tackling larger projects.Overall, these clamps provide solid, accurate alignment and make cabinet face frame installation a bit easier.
Bill
Reviewed in the United States on November 2, 2024
I've been using old school wooden parallel clamps for screwing together cabinets since I was a kid. They work, so I never really thought of updating them with anything else, plus I'm not installing cabinets so regularly anymore. When I saw these, I had to give them a try.They come with foam pads, which they don't tell you about in the instructions. You can figure out where they go with a little inspection of the shapes. They are there to help protect the cabinet frames. Have someone hold the clamp while you apply those foam patches because you have to really get them in the proper place and they are very sticky. If you land one wrong, you'll probably destroy it trying to remove it and try again.Many cabinet manufacturers don't have clip on doors anymore, so in order to use this on a hinge side, you'll have to remove the hinges. I like that you can clamp these right where you need them, then get everything flushed up, screw the pilot hole on one side, then flip the screw guide down and actually drive in the screw -- all while the clamp is in place.They're not perfect. The screw mechanisms aren't all that smooth. They're also limited to the size style they will fit (although it will fit most). Another obvious limitation is that they won't work with full overlay doors. But for what they're designed to do, they do it well enough to earn five stars.
GY
Reviewed in the United States on November 18, 2024
I assembled the base cabinets on one wall without these, and then used these to have all of the uppers after ordering them. WOW!, Much easier with these. I did buy another one from the Big Orange box store, but returned it because one clamp cost me as much as both of these, AND these are better quality.
snowleopard
Reviewed in the United States on November 14, 2024
I’m not installing a cabinet at the moment, just assembling the things I need to convert my garage into a workshop.These are really gorgeous little tools. They are well machined, and operate cleanly. They’re obviously well-made, and made to last. I expect they will outlive and outlast me.I’m already thinking of some way to casually store them out in the open so as to elicit tool envy. If you’re not wired that way, they come nicely boxed for storage. They had me at hello, but then they threw in a free drillbit. That’s hardly playing fair.
Recommended Products