Your cart is empty.
Your cart is empty. RSHTECH Dual Bay SATA Hard Drive Docking Station equips 4-in-1 function, including storage, clone, USB hub, and Card reader.
Supports UASP protocol: UASP (USB Attached SCSI Protocol): supports for HDD/SSD faster transfer performance, 70% faster than traditional USB 3.0, requires UASP capable host controller and operating system. (Real-world performance depends on the disk drive and host system.)
Supports up to 2x 16TB hard drive： USB 3.0 dual-bay Hard Drive Docking Stations can access both disks simultaneously. Maximum Capacity of 2x 16TB.
Offline Clone Function:
-Ensure the Power Switch on the rear is in the OFF Position and plugged in properly.
-Insert Both hard drives and identify the Source Disk and Target Disk (Make sure the memory capacity of B drive is larger/equal than A drive )
- Make sure that the USB cable is disconnected from any computer during the cloning.
- Press the "Clone" button for 3 seconds until the LED starts to flash and the cloning process begins.
-Progress indicator with LED: 25% - 50% - 75%-100%. When the offline clone operation is fully completed, all LEDs will constant on.
Note:
-The offline clone function cannot be processed if there are bad sectors or tracks on the hard disk.
- Do not try to remove your HDD or SSD device while it is active. After the data transfer is complete, eject the drive from the computer and press the HDD Dock power switch to the OFF position.
-Please backup files in the target hard drive before cloning. Any files in the target hard drive will be overwritten when offline cloning occurs.
FAQ: HDD is not recognized by the Computer
-New or old HDD may not be initialized or formatted(if there is data on the hard drive, please backup it in advance).
-There is unallocated space on the hard drive.
-Please connect the hard drive dock enclosure to the computer's USB 3.0 port to achieve the best transfer speed.
Ricardo Belmar Berumen
Reviewed in Mexico on July 5, 2024
Aparentemente todo funcionaba bien, pero en mi caso después de unos tres o cuatro meses de estar usándolo, de pronto veo que un seagate de 4 TB que tenía insertado ya no era reconocido por Windows, la tabla de particiones del HD se había corrompido y no hubo manera de repararla con ningún programa por lo que tuve que hacer una recuperación de archivos con el EaseUs Data Recovery, este fallo primeramene se lo atribuí a que el HD era de mala calidad. Pasó este incidente y después de un tiempo nuevamente para mi sorpresa sucedió lo mismo pero ahora con dos HD's que tenía insertados al mismo tiempo en la unidad, uno de 4 TB donde estaba haciendo mi respaldo y el otro de 2 TB donde tenía la información de origen que quería revisar y duplicar de manera manual porque la unidad ya se estaba llenando e igual, después de varias sesiones a la hora de prender este aparatito para seguir trabajando con mis archivos, veo con horror que ninguno de los dos HD's eran reconocidos y que al igual que en el primer incidente de meses atrás, la tabla de particiones de los dos Discos Duros se había perdido y sólo se mostraban con formato RAW en el administrador de discos, aquí ya se me hizo muy raro que el fallo sucediera en los dos HD's que tenía insertados al mismo tiempo por lo que empecé a desconfiar de esta unidad acoplamiento, este problema jamás se me había presentado en otra docking station viejita que tengo desde hace más de 8 años de la marca Thermaltake, la BlacX Duo que desafortunadamente solo te lee hasta 2 TB's, todavía la sigo usando pero dadas sus limitaciónes me era necesario tener una que pudiera leer Discos Duros de mayor capacidad, razón por la cual había comprado esta nueva de la marca RSHTECH para poder así trabajar con HD's de 3, 4 o más TB's y bueno después de este segundo fallo, yo todavía de necio quería creer que era problema de los Discos Duros, pero nuevamente ahora después de que hace unas pocas semanas quitara un HD Toshiba de 3TB de la serie X300 que estaba trabajando perfectamente bien dentro de mi computadora y que lo empecé a usar de manera externa en esta unidad de acoplamiento RSHTECH ¡ Sorpresa ! No pasaron ni tres días y mismo problema y además también me hecho a perder la otra tabla de particion del otro HD que también estaba insertado de la marca Western Digital por lo que definitivamente ya no me queda ninguna duda de que este aparatejo tiene algo o hace algo que en cualquier momemto te destruye las tablas de particiones de tus Discos Duros y te los deja irreconocibles por lo que definitivamente NO LO RECOMIENDO. Lo grave es que te das cuenta de este problema ya que pasó algún tiempo y tu garantía ya expiró como es mi caso por lo que lo único que me queda a mi por hacer es tirar este aparato a la basura.
ThomAce
Reviewed in the United States on May 25, 2023
The item shipped quickly by the seller and come in perfect condition. The box is well structured and inside the unit itself placed in a plastic bag, a warranty card and in a separated section the USB cable and a 100V - 220V switching power supply. Since there was no possibility to choose, it shipped with US plug. But, it is not a big problem because the unit can be used either in 110V or 220V. However, whatever I tried, I was not able to reach the 5Gbps transfer speed with the unit. However, a 3Gbps speed seems rock solid. Tested with multiple SSDs, HDD and SSHD. So, you can expect something around 370MBytes / sec read and write speed on the attached disks. (if you have fast disk enough of course...)Pros:- Plug & Play, no need to install, no tooling needed.- Nice design, completely fits in modern desktops.- Aluminimum frame- The lights not too strong, so it will not disturb you- micro SD and SDXC reader. However, in my case it was not super fast. ~35MB/sec.- Two additional USB3.0 connection with USB2 backward compatibility. So, you can use your older cam for example...- Good sticking, thin enough rubber feets- Comes with USB cable and power adaptor- Quality materials usedCons:- The SATA section can be dettached from the system only together. So, if you have two disks and wanted to change one, you should "drop off" both.- Do not try to plug an heavy, standard 7200RPM HDD while the unit is on... Most likely it will fail to start. Switch off, insert your HDD, switch on.- thin SSDs might not being hold tightly enough.- The SDXC reader showing only USB2.0 speed & device.In a scale of 1 to 10, I would give 8 or 9. The decvies is near perfect.If you are looking for an a good and stable device that not heating up and having multiple connectivity (micro sd, sdxc, 2 usb 3.0 ports and 2 SATA dock with capability to run 3.5" HDDs as well, this would be a good choice for you. If you are looking for a closed docking station for your disks, this might not be the best for you.Summarized the whole: It worth the money. The games running great and loading in really fast from the attached SSDs. Great value for the money, recommended product.
J.Daniel Castillio Mejia
Reviewed in Mexico on September 29, 2022
The media could not be loaded.
Israel Gutierrez Ramos
Reviewed in Mexico on July 27, 2022
No le pongo 5 estrellas porque cuando está trabajando e inserto una USB en la PC deja de trabajar se cambian de letra las unidades, fabricantes chequen ese dato
ELOY MORENO
Reviewed in Mexico on June 8, 2022
muy bien todo. solo que tengo q apagarlo por separado. despues de apagar la pc
José Luis
Reviewed in Mexico on July 23, 2021
Es un equipo con materiales de buena calidad, fácil de instalar, cuenta con 3 puertos usb 3.0, lector de trajeta TF y Sd,aspecto elegante y muy funcional en definitiva una muy buena elección
Orcatrainer
Reviewed in the United States on May 18, 2020
The docking feature is pretty much essential if you want to get on-hand access to large amounts of data. In this day and age, standard spinning-disk hard drives come with pretty reasonable cost per gigabyte and getting generous multi-terabytes of storage space doesn’t represent such a huge investment like in the past. While you keep those drives on hand, you can easily pop them in or out of the hard drive docking station according to your needs.Whether you want to clone your hard drive to SSD or require occasional access to bare drives, this RSHTECH dock is a dual-bay hard drive docking station that’s perfect for the job. With the super speed of the USB 3.0 interface, it’s ready to tackle all your needs quickly and efficiently. For a dual-bay model, it’s priced quite fairly in my opinion, considering its powerful abilities.I also really appreciated the fact that this dock uses a redesigned cloning technology which can copy your important files from one disk to another without the need for a computer. All you have to do is plug the hard drives together and keep the ”Copy” button pressed for a few seconds until you see the LED flashing. This means that the cloning process has started and to track the progress you can check the LED which has four stages from 25% to 50%, 75%, and finally to 100%. Keep in mind that when you're cloning your drive, the capacity of the B drive (target) should be larger/equal than the A drive (source).Overall, I am pretty happy with this purchase, and so far I haven't bumped into any technical issue with this dock.
Ryno's Stuff
Reviewed in the United States on January 31, 2020
Really happy with this hard drive dock. It is exactly as advertised and connects through USB3.0. I have had zero issues with it reading or writing, and the speed is fantastic compared the the old dock I was using. Glad it also has additional ports to connect my other external drives to. I value file redundancy, haha.Very compact design. Made of sturdy plastic. Cords to connect to PC and to the outlet are plenty long. MicroSD and SD readers also work at high speed.Nothing to complain about! Really pleased I found this for such a good price.
henry
Reviewed in the United States on November 17, 2019
This product is very well built, feels very solid, it has a metal enclosing instead of plastic. It works amazing well on both my windows desktop and my macbook pro. My two harddrive (1.5 TB and 8TB) can be detected correctly, and on mac, other than data storage, you can also use it for time machine backup, which is pretty neat. This dock station also offers two 3.0 USB ports, I tested with my flash drive, I am getting a transfer rate around 120MB from the drive to the PC, which is within my expectation for a USB 3 port. The SD and MicroSD card slots are definitely a plus, I’ve used it a few times to read data from my phone and camera MicroSD card. Overall, I am quite happy with the purchase, with the features it provides, I no longer need to keep two docks, usb hub and card reader on my desk.
Recommended Products
