Shopping Cart

Your cart is empty.

Your cart is empty.

Gas Powered Snow Sweeper Brush Broom, Cordless Hand Held Walk Behind Power Shovel Snow Cleaner for Driveway Lawn Garden, 52CC 2-Stroke, 2.4HP, 27.2'x10.4'

Free shipping on orders over $29.99

$257.00

$ 99 .00 $99.00

In Stock

About this item

  • Professional Cleaning Ability: This snow blower is designed to remove snow, pebbles, sand, grit, or Leaves without damaging the grass and for clearing away water and light snow from hard pavements
  • Strong and Durable: The motor of this power broom adopts an air-cooled motor engine, which is tough, wear-resistant, and corrosion-resistant, extending the service life of the broom.
  • Time and Effort Saving: Compared with ordinary paddle, the snow plow is powered by a motor that can save time and effort, making it easier to operate.
  • Large Cleaning Area: This leaf sweeper has a large cleaning area, allowing you to clean more areas at the same time compared to a normal broom. could removes dirt and leaves effortlessly, but also reliably clears snow from driveways and sidewalks in winter
  • Easy to Operate: The total length of this snow broom is 79.5inch, so it can be used with people of different heights. Moreover, the gas paddle is equipped with a curved handle, which makes it easier and more convenient for you to operate.


Specifications:

Color: Orange/Black

Type: Single-Cylinder, 2-Stroke, Air-Cooled

HP: 2.4

Displacement: 52CC

Max Power: 1.7KW/7000RPM

Fuel Capacity: 1 Liter

Oil/Gasoline Mixing Ratio 40:1

Brush Material: rubber

Sweeping Paddle Size: 27.2"(W) x 10.4"(Diameter)

Overall Length: 6.6ft (approx.)

Certification: EPA


Danielle
Reviewed in the United States on February 1, 2025
It works very well, but I have had some problems with the carburetor choking up and it had to be thoroughly cleaned. Once I did that, it has done a great job. I use this for dirt/small rocks not snow.
Tim & Linda Montgomery
Reviewed in the United States on January 4, 2025
The secret to the snow broom is adjust shoulder strap . I cleared sidewalks for Doctors buildings and when it snowed it could be bad. You start it tilt it a little bit it. Clears snow as fast as you walk! And then if you have to walk with it to the other side of building just flip the unit over hit the throttle and it and it will basically pull you along !
Nick Dispenziere
Reviewed in the United States on February 6, 2024
Works perfect. Fixed edges of stone driveway after plowing season. A little heavy but did the job.
Jim in Kansas
Reviewed in the United States on October 26, 2024
So far can’t get engine to start. No returns. Buyer beware. Edit: I was able to get engine to start and it is working properly. I bought this to push acorns out of my yard. I think it will do a good job. Very heavy unit. I am adding extra wheels to help with the load.
Mark Vaughn
Reviewed in the United States on January 25, 2024
I got this to sweep acorns off my yard without messing up my grass. It works really well with very little harm to my lawn. Works best when the ground is dry. It is very front heavy. The instructions were absolute garbage. You are basically on your own putting it together. The engine runs well with plenty of power. Sure beats hand raking acorns or using the leaf blower.
Brian
Reviewed in the United States on January 20, 2024
I bought this because I was looking at just the lower attachment for my existing weed cutter. But the attachment cost almost 500 dollars. So fore less than 300 dollars I have an entire dedicated power brush.PROS: It clears snow great. (The reason I purchased it). For a no brand motor it start easy and I had no issues using it.CONS: The reviews about these being HEAVY are correct. Not something you want to hold off the ground while using it. I just let the roller stay on the ground and steer it where you want it to go.There are NO instructions on assembly. NONE. You have to figure it out from the parts diagram. But it only took me about 45 min to assemble. NOTE: you will have to loosen the grip/throttle to let tension off the throttle cable to allow you to connect it to the carburetor. When tightening the bolts on the rollers gear housing, just pull the carter pin and remove the one side of the roller. And the gear housing stayscloser to the ground not on the top.Over all I am pleased for the money. I don't plan on using it for cleaning a lot of area. And only once in a while. Like snow days or when I edge my sidewalks and a bunch of clipping and dirt accumulate.