Your cart is empty.
Your cart is empty.Product Description
3/8" (dia.) Double Flute Straight Bit with 1/4" shank, 2-11/16" overall length
From the Manufacturer
These bits cut smoother than other straight bits because of the precise shear and hook angles. End of bit relief allows for fast plunging. Covered by Freud's limited lifetime warranty.
william osorio
Reviewed in the United States on July 9, 2024
Worked great
Sims
Reviewed in the United States on July 6, 2024
Worked like a charm, great quality
Mark Fields
Reviewed in the United States on June 14, 2024
Its worked fine so far.
Bruce Sayre
Reviewed in the United States on December 17, 2024
Very sharp, cuts well. Good quick service.
Ed A
Reviewed in the United States on October 26, 2024
I’m using this in technically outside of the typical application. Where I should really be using a spiral up cut, I’m using this with excellent results. Application: pocket hole cutting for washer head screws in softwood/plywood.
Jesse
Reviewed in the United States on December 7, 2023
What else is there to say it's the Diablah!!!!
MJV
Reviewed in Canada on January 31, 2022
Works great, nice to see Diablo is still making quality products, not like the others jobbing to some Chinese factory to make low quality junk.
P.J.
Reviewed in the United States on July 31, 2021
So, if you're opening this package, you might be tempted to try to grab the bit and pull. You'll have two nice deep slices on your fingers in no time. Its really easy to get out if you don't do this. Tear the sticker off the sides where it says Pull Here. Then, take a small screw driver or something round and thin, and just push the bit out of the plastic from the bottom. There's a hole for this. Why they don't draw attention to it, I'll never know.Oh, and these bits are awesome and better quality than just about any cheap bit you'll find on here.
rob norman
Reviewed in Canada on December 6, 2021
worked good
DvdGsp
Reviewed in Canada on November 10, 2021
Does the job. Good product.
Graham
Reviewed in Canada on January 20, 2021
Worth the extra money for the genuine "Freud" item - the router-bit is sharp and long lasting. Cheaper bits wear-prematurely when used with hardwoods
George
Reviewed in Canada on September 20, 2020
Good quality drill bit, used it to drill quite a few holes and it is sharp, precise, no wood burn (did not rush the job, did it in several passes). Drill still looks like almost new. Recommended.
Lampheat
Reviewed in the United States on May 24, 2014
This bit was sharp and had no issues cutting through the pine and fir I was using. Because of the depth this one is quite versatile. Nice packaging in a solid plastic case.
Recommended Products
