Your cart is empty.
Your cart is empty.24 inch x 3 feet Flexible Magnets Brand Made In USA Flexible Magnetic Material, White Vinyl Front you can add any sticker material or even pain it, super strong .30 thick long lasting material.
Ben
Reviewed in Canada on August 1, 2022
The page says 24 x 3 feet, with a picture of a large roll and a hefty 64$ price tag, so I assumed it was 24 feet long. What I recieved is 2 x 3 feet, the size of a small poster ...
heather harper
Reviewed in Canada on July 22, 2021
Absolute junk. Put them on my car and they flew off once I got on the highway. Definitely not strong enough for vehicles what a waste of money
Art
Reviewed in the United States on January 30, 2018
I bought this to cover the air vents on my fireplace in winter when the cold air around the outside of the firebox creates a cold draft by pulling warm air into the top vents and pushing cold air out the bottom vents.Anyway, after cutting the pieces to size, about 4 x 12 inches to cover each of the 4 vents, I cannot get the material to flatten out. I left it under heavy boxes overnight and still the edges curl. I reverse rolled it, which helped temporarily, but after putting it on the fireplace the edges still curl after a few hours, uncovering part of the vents. The magnet is very weak; if it was stronger maybe it would hold itself down better.Not recommended for this use. Maybe good for other purposes.
JMichele
Reviewed in the United States on January 22, 2017
I was surprised to enter my new condo on the first real bitterly cold day this winter to find the place as frigid as if I had left a door open. I bought this sheet magnet, as others have, to cover my windy fireplace vents.It came in a tightly wrapped roll, covered in thick protective plastic. I unrolled it and let it rest near my baseboard radiator, held down at the four corners by the 4 legs of a table. It flattened nicely. I used a box cutter and sheetrock T-square to measure and cut 2 straight 7" x 36" sheets. This sheet was more than adequately sized for my purpose, and I have a large piece remaining. I left the white paper covering on. I had also purchased rare-earth magnets to support this sheet magnet, as many reviewers indicated that the magnet may not be strong enough to hold on a larger vertical surface. When I placed them on my fireplace vents, however, I found that the magnetism was more than strong enough to support the magnets vertically.I will retain the rare-earth magnets, however, as I plan to purchase and hem pieces of brocaded cloth to cover the sheet magnets so that they look attractive in my great room.I am very pleased to find such a simple and inexpensive fix.
Wicomico County Sheriff's Office
Reviewed in the United States on August 17, 2016
Very fast shipping. I bought this for a intake vent that I wanted to block off and make the AC draw from a hotter area more. The grate is metal however this does not like to stick to it. The material is very durable, I would just need a little more magnetic strength to make it perfect.
Ryan S
Reviewed in the United States on October 7, 2016
This worked great to block off a vent in my ceiling. I had read some reviews stating it did not work for this purpose, so I was a little worried but decided to order and try it anyway. I measured the opening in my vent and cut a sheet the appropriate size. It was a little difficult sliding it in place, since it wants to stick to the metal. It works great! Even though there was a lot of air pressure coming out, it stays put.There are some types of ceiling vents that are not steel, perhaps that is the problem the other reviews had. I have both types in my office, I've included photos of each.
Shawn Mccadden
Reviewed in the United States on January 28, 2016
This stuff had almost no magnetic ability at all. I bought it to cover heat vents. It would not even stick to them at all. At first I thought the vents might be aluminum when it would not cling, but it was the product that was useless. I had some magnetic strip tape and attached it to the cutouts I made and that stuck like glue! Advertising this a super strong is misrepresenting the product. I wish Amazon would test these products before offering them on their site. At the cost it was not worth my time to return the failed product.
Tiffany R.
Reviewed in the United States on September 6, 2015
I bought this to cover a 16"x20" air grille in my ceiling but with the grate spacing, the magnet was not strong enough to support its own weight. This product may work better on floor grates and looks to have many other potential applications but it does not work as a cover for ceiling grilles.
WME
Reviewed in the United States on August 26, 2015
Delivered on time and as described. I have to add that it is strong and holds well. I use it to cover a leaking sun roof. I normally take it off prior to going anywhere, but I have left it on by mistake and it holds well. I disagree with the negative comments about the magnet being weak.
rustyredcab
Reviewed in the United States on September 9, 2014
Not a precise cut or size. More like a rough estimate and cut to be at least the 24x36 I ordered. I am using it in a poster frame for spices and needed to cut sheet to get clean (enough) edges and an exact 24x36 size. Backing was a BIG problem for me. It is stuck so hard to the magnet that it does not peal off easily. I gave up pleading all but a bit of the corners after ripping the magnet trying to peal off the back. The sheet is very flexible and therefore would be better if it could be stuck everywhere on a backer. But, using much care, I still ripped on conner off so I elected to adhere it to just small corners instead of the entire back. For my use, the ripped corner does not show. Your use may be different. Just beware that you can not simply peal and stick since pealing if very difficult and I don't know how you'd peal the entire 24x36 backer.The magnet is strong enough to hold spice tins but is not strong. If I were to do it again, I'd get the stronger one.
Recommended Products
$48.32
$ 23 .99 $23.99