Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
Robbg77
Reviewed in the United States on March 7, 2025
Fit perfectly. Made for an easy repair! Made with quality material that you would expect from fel-pro !!!!!
JQuard
Reviewed in the United States on March 1, 2025
Quality gasket. Fit my car perfectly.
Ismael rangel
Reviewed in the United States on January 27, 2025
Work perfect ina 2004 ford ranger 2.3
Jon Burgoyne
Reviewed in the United States on September 20, 2024
easy to install, looks like it will perform better than orig
Luis
Reviewed in Mexico on June 4, 2024
Ya llevo 3 meses que lo cambie y no tira ni una gota de aceite y ya el calor supera los 100 f
J. Raúl Mote
Reviewed in Mexico on May 30, 2024
La pequeña fuga de aceité se elimino , ya era justo el cambio después de 13 años
Jay C
Reviewed in Canada on March 2, 2024
Worked well, easy to see and install with the blue color.
Mikey D
Reviewed in the United States on March 15, 2024
I always use fel pro and this gasket set worked as it should. No oil leaks from valve cover anymore. Its priced better on here than most of my local part stores.
amac12674
Reviewed in Canada on December 21, 2024
Direct fit, good buy.
Michael P.
Reviewed in the United States on December 16, 2024
Went together in a breeze
Moose
Reviewed in the United States on November 28, 2024
worked great, stopped the oil leak and help up wonderfully, just remember to use gasket maker on the points where required. Where the head splits.
N Wayne
Reviewed in the United States on April 6, 2024
Thanks a good quality gasket set, that being said however for the 2.3 engine I found the middle gaskets fit perfectly and it sealed nicely but the large outer perimeter gasket was about a half inch too long. I had to cut it then put a little fipg on the seam. Not a huge problem but be prepared for it. You can't cram it all in the rail, at least on this engine, be prepared.
Etienne Gallant
Reviewed in Canada on October 13, 2021
Perfect fitment and easy installation on 2010 Ford Duratec 2.0.**This is the gaskets you will need if your spark plugs wells are full of engine oil** All 4 gaskets were simply a pleasure to install in their valve cover grooves. Figure approximately 60 minutes of wrenching and most of all cleaning and preparing surfaces. There is 14 valve cover stud/bolts. Each will need to be torque down in the proper sequence to 89inches-pound. Also make sure you have some gasket maker available for those 2 casting marks where the cylinder head meets the timing cover. This step is often forgotten!Fel-Pro is really a premium quality source when it comes to automotive gaskets.*UPDATE DECEMBER 2024: valve cover area has not developed any leaks after 3 years and approximately 30000km extra mileage. Follow Ford workshop manual with this quality part and you will be golden*
Recommended Products
$36.19
$ 16 .99 $16.99