Your cart is empty.
Your cart is empty.
Fit for Hyundai Elantra 2011-2019, Sonata Hybrid 2016-2019, Tucson 2015-2019.
Fit for Kia Forte 2014-2016, Optima 2017-2019, Sportage 2016-2019, Soul 2012-2019.
Fit perfectly on 2013 hyndi elantra
Reviewed in the United States on February 22, 2025
Had a leak on my 2013 elantra and replacing this gasket fixed the leak.
Maimor
Reviewed in Mexico on January 9, 2025
Es la pieza exacta que necesitaba, buen producto
Daimy Fernández
Reviewed in the United States on August 21, 2024
Producto exacto para kia forte 2015
Cindy DeHart
Reviewed in the United States on July 21, 2024
Fit will. I must say that I needed to use just a bit of silicon, randomly in spots. I allowed it to dry and then installed the cover. held it in place for assembly….
JESUS FLORES
Reviewed in the United States on July 17, 2024
Ok
Yolwuin
Reviewed in the United States on June 28, 2024
Bueno
teri bennett
Reviewed in the United States on February 1, 2024
Like others have mentioned, the gasket is of lower quality then oem and will leak from the back corner like crazy, if you have to replace your gasket use fel pro or oem, if you use this one you will end up having to do the job again.
D.D.
Reviewed in the United States on July 16, 2022
EDIT: ADDED PHOTOS. THE LARGER ONE IN THE PHOTOS IS THE ORIGINAL FACTORY GASKET.I though I was getting a deal here but I ultimately got what I paid for. Lifelong experienced mechanic, I should have known better. I noted when I had taken it all apart that this gasket was a little bit smaller in diameter (as if you had cut it in two and looked at a cross section) than the original I pulled out. It was the same design layout exactly. I had concerns, but I was doing this in the middle of the night and had to get it back together and just really hoped it was still "big enough" to seal the valve cover. The original I had pulled out was quite brittle so I couldn't put it back in. I was stuck with this one. And it failed.Immediately after getting everything reassembled and starting the engine, oil oozed out on the back side of the valve cover (it's on an incline with the back being lower) right onto the exhaust manifold which of course then burned off and smelled terrible. It was all torqued down to specs, and my concerns about the gasket being slightly smaller in diameter than the stock one were shown to be worthy of concern.I basically wasted my money and time here with this gasket and regret purchasing it. Since any of the aftermarket big name gasket makers don't seem to have one (like Felpro) I'm going to have to special order one from the dealer (out of stock of course) and do this job again.Just do yourself a favor and skip this one.
Matt J. Young
Reviewed in the United States on November 3, 2022
Great quality and price. Very comparable to factory part. Great Fit and easy to install. Took a less than 10minutes to take the old one off and only a few minutes to put the new gasket on and tighten all of the bolts back.. As a side note, do not over torque the bolts while putting the valve cover back on. Most torque wrenches usually only goes down to 5lbs of torque and this valve cover is only around 3.5. ...DO NOT over tighten or Over Torque... The head of the bolts WILL Snap off. Tighten down without over- tightening. You will be able to feel it. Tighten then STOP when it doesn't turn anymore.
Recommended Products
