Your cart is empty.
Your cart is empty.Product Description
-
-
Universal Oil Cooler Kit
The stacked plate oil cooler has 10 and 15 rows. Improve the lubricating effect of engine oil.
-
Universal Oil Cooler Kit
The stacked plate oil cooler has 10, 16, 19 and 30 rows. Improve the lubricating effect of engine oil.
-
Transmission Oil Cooler Kit
The oil cooler has 4 pass, 6 pass and 8 pass. Help to reduce transmission fluid temperature.
-
Nylon Braided CPE Fuel Line Kit
The CPE fuel line can widely used in various scenarios. Compatible with transmission fluid, oil, race gas, and fuel,etc.
-
Transmission Oil Cooler Hose SAE J1532
Specifically designed for transmissiom cooling systems, provide heat and oil resistant transfer for transmission oil coolers.
Yuno Miller
Reviewed in the United States on August 25, 2024
I really like how easy it was to install since I have installed it on my Honda. I haven’t burnt oil as fast so if your car runs hot this is the way to go.
Abdulmalik S ALAKLAN
Reviewed in Saudi Arabia on August 16, 2024
Looks and works good... I'd recommend to combine it with a trans cooler for optimum performance...
Travis Vo
Reviewed in the United States on July 19, 2024
Worked for a while, I only drive 5-20 miles at any given time. Well i took a little road trip into the mountains and desert (200 miles). When I came back home, there was a puddle of oil on my driveway. I figured it might just be a fitting on the hose that jostled loose. Tighten the fitting connected to the nipple on the cooler. Drove around a few more miles and it gotten progressively worse. Found out it was the actual cooler itself that was leaking from where it connects to the nipple. The pressure from the extended drive caused it to burst? Who knows, I was lucky that I didnt loose that much oil I was on my road trip (lost half a quart). Seems like a common factor among reviewers, quality check is lacking. Stay away from this brand, I've bought an lines and an fittings including this cooler and it all leaks one way or another but no more. Buy elsewhere before it costs you an engine replacement.
Gary E.
Reviewed in the United States on December 22, 2024
Put this on my 87 Buick GN. Connected to factory remote mount oil filter plate. Did not use the supplied plate. Hoses reached to the front on the AC condenser perfectly. I did have to purchase 2 additional 90° AN fittings, but no fault of EVIL. Uses approximately 1Qt of oil capacity (top off after first warm up). I am now a huge fan of EVIL kits and intend on purchasing their fuel kit next.
adam
Reviewed in Canada on May 18, 2023
Installed in my 325i street/track car and was honestly amazed not to have any leaks seems sturdy over a year later and a couple track days .very happy with it. Would buy again.
Jaden
Reviewed in the United States on October 7, 2023
This kit worked perfect on my g37 and a 1/3 of the price of others. The lines were perfect length and I was able to use my oem oil filter. To be safe I double checked all the fittings to make sure they were tight and I used Teflon tape, so far no leaks! I also used my own 90° brackets to mount it behind the crash bar
BB T.
Reviewed in the United States on October 16, 2023
The media could not be loaded.
Kenneth
Reviewed in the United States on June 24, 2022
Purchased it for a 95 Talon TSI but have since ditched the sandwich adapter for an oil filter relocater. The fittings are pretty basic, the hoses are cheap but they are easy to trim to length and are more than adequate, the cooler is sturdy, and the sandwich plate is good but the included oring is iffy. Idk if it works TBH. When I first installed the unit it bottomed out around the oring with a quarter turn of the nut after contacting the oring. Bad seal? Maybe. Run to Walmart and purchase a fram ph4386 filter. Chuck that origional oring out because the gasket from that filter works perfectly (keep the filter so you don't forget). I feel like many of the bad reviews are from people who did not take the time to look things over before installing them. Take things apart and inspect them before installing. I have been using this product for almost a year now with absolutely 0 issues on an oil system that sees up to 100psi at redline.
Sarah S.
Reviewed in the United States on September 1, 2021
This kit is NOT universal. The adapter plate doesn't fit the oil filter location on the older style SBC 350 engines. Aside from this issue, the kit appeared to be good quality. I wish the seller had a different model to fit the SBC 350 engines. I believe this could have been installed but it would require a smaller oil filter than stock. This didn't set well with me so I returned the kit.
Dave
Reviewed in the United States on August 6, 2021
What I love is that it is easy to connect. It looks good. Mostly complete kit.Improvements that could be made: Tubes are almost too long though and would be better if it had 90-degree elbows at both ends.Knocked a star because the lack of mounting hardware included. Mine was a simple mount into an Isuzu Trooper, but the way the ears are on the cooler makes it so you have to to have a 3D twist and a bend to mount it to the cross member in the front of the radiator. Had th custom fabricate that.Five stars would have included the brackets, but not in this kit.It is a little thicker then I thought it would be, but it is doing an admirable job keeping the engine oil cooler!Updated 9/29/2021–No way to contact company about the leaking hose!!! Will have to lower the review to 3 stars because the hoses are not that good. Only had it in the car a couple of months and the hoses sprung leaks. Mechanic suggested new hoses. I hate doing things like this twice!!
Recommended Products
$49.99
$ 25 .99 $25.99