Your cart is empty.
Your cart is empty. Used for polyurethane or nylon tubing.
This product is pneumatic quick connector, cannot be used repeatedly.
Bill B.
Reviewed in the United States on February 22, 2025
The fit and finish of these are good, they hold the PTFE tube well and release easy enough as well. The thread are clean cut and are the advertised size. ......But....The problem I have with ones I received is at the thread end were the filament comes out, the edges of the hole are sharp and scrape the filament going in or out as there is no bevel. I had to bevel every one by using an air tool and drill.Photos show sharp edges and last photo shows beveled work I had to do.
John R
Reviewed in the United States on March 29, 2024
The original couplings on my ender 3 were shot. This came quickly and got me back up & running in 10 minutes.
James Morrow
Reviewed in the United States on December 4, 2024
Just what I needed, worked exceptionally
Sandy
Reviewed in the United States on December 18, 2024
Easy to install
JP and cody
Reviewed in the United States on October 17, 2024
I've had one of these on my CR10S55 for 6 or 7 LARGE prints now. No issues.
Evan
Reviewed in the United States on September 29, 2023
Was a direct fit and easy replacement. The clamping has held up well and I would definitely recommend for use on 3D printers.
Zach R.
Reviewed in the United States on November 26, 2023
This worked as expected. Fit perfectly for the one I snapped off on my Monoprice Select Mini V2 3D printer. Easy to install and the value is good since I now have plenty more replacements when I inevitably over tighten again in the future.
States
Reviewed in the United States on January 4, 2020
These have nine metal teeth to hold the tube compared to four teeth in the fittings that came with my 3D printer. They do hold the tube more securely than stock, but I do still see a bit of back and forth movement during printing.
Recommended Products
