Your cart is empty.
Your cart is empty.Product Description
stlmaj
Reviewed in the United States on February 17, 2025
Worked great bored aluminum cylinders .020 over with no problems.
THOMAS POETA
Reviewed in the United States on July 26, 2024
Stones didnt fix right and broke while putting on
Glenn Biggers
Reviewed in the United States on July 26, 2024
The drive shaft is too large for 1/2" chuck so had to grind down the flats in order to try it. I started to use it and found the stones did not stay bottomed in their holders even though clamps were tight and it had a sloppy feel to it and was awkward to move. I stopped using it and ordered a Lisle 15000 as I was afraid of damaging cylinder. I had a Lisle 15000 before and it is much easier to use with a portable drill and gave excellent results. I regret this purchase and will not return it as I modified the driveshaft. Use a Lisle for a portable drill!
randall browne
Reviewed in the United States on May 15, 2024
comes in a nice storage case. two holes honed so far and no problems nice tool
Verified customer
Reviewed in the United States on March 28, 2024
I will update after using, but arrived very fast, nice wood box, stones of 120 grit 180 220 & 320 grit.Bought for bore honing three virgin 60mm cylinders to 60.400, will update when finished.Update:Some of the stones have the steel backing incorrectly affixed so they wont fit in the mandrel.The 120 grit stones aren't flat on the back plate, so they rock in the mandrel, totally useless.After much screwing around I got a cylinder overbored .0020", but on the final strokes the tool kept chattering in the bore, so I've got a perfect bore with chatter marks in two places. Fortunately they are below the rings so no performance degradation, but it sucks that they make a potentially excellent tool so poorly that it fails at it's designed task.Maybe You'll get a good one. I had to take this one apart, file smooth all the slides, change the spring retainers, & file the backs of every stone, but now I'm boring 19 thousandths within a quarter thousandth tolerance!Bore with 120 grit to within .0030"Finish boring with 180 grit to .0020"Rough Hone with 220 to .0010"Finish Hone with 320 gritPlateau with a clean WD40 soaked ScotchBrite pad vertically just once down & once up to cut the peaks off the honing scratches, don't twist or spin in the bore or You'll be smoothing the valleys that hold the oil.I'll be buying the 50mm to 75mm next, overall best tool for the job under $500
Curtis Barclay
Reviewed in the United States on November 22, 2024
Works as expected👍
Charles Cummins
Reviewed in the United States on October 23, 2024
Awesome
Fabworks
Reviewed in the United States on September 14, 2022
Great company to work with. Excellent communications. Tool quality is well built. Nicely packaged. We bought 3 sets of these tools. Used it on a cylinder job and it simply just worked as expected. We will be looking for other products from this company in future.
Recommended Products