Your cart is empty.
Your cart is empty.Brush Research’s FLEX-HONE® tool has now been specially crafted for a wide range of Firearms applications. The FLEX-HONE® for Firearms tool quickly and easily produces the optimum plateau surface finish in any type or size cylinder, slide, chamber, magazine tube or smooth bore barrel. Emptying and reloading your firearm will be much smoother and easier after using the FLEX-HONE® in the cylinders and chamber. The improved finish will allow the rounds to “fall” from the cylinder with ease, and eject smoothly from your chamber. Reloads will enter quickly and smoothly with reduced brass scarring. A FLEX-HONEd bore will enable you to reload your brass more often and with less work.
Scott W.
Reviewed in the United States on May 6, 2024
Works well. I have a 454 Alaskan with tight cylinder chambers. No scrubbing with a bore brush would help. A few passes with this cleaned everything up. Make sure you use oil. If I were to do it again I'd get both grits.
William Parsons
Reviewed in the United States on April 11, 2024
I have two of these. One in 357 and one in 44. I had been shooting 44 Specials in a 44 Mag revolver and 38 specials in a 357 Mag revolver. After a period of while, a crust will build up in the chamber just in front of the shorter cartridge. This crust is very difficult to remove with normal cleaning methods. These clean out this crust slick as a whistle. Not to mention polishing the chamber to facilitate smooth ejection of fired rounds. A must have item for Cowboy Action shooting.
Jennifer
Reviewed in the United States on September 19, 2023
good
Mark Sligar
Reviewed in the United States on May 29, 2023
I used the on a Ruger Vacauro 45 Long Colt, now the empty rounds drop out without using the ejector.
Jeff
Reviewed in the United States on March 28, 2023
Honed out the cylinder on my 357. Make sure you use honing oil.
C R M
Reviewed in the United States on November 25, 2023
I used this hone to clean up a rough finished chamber that was causing issues when dirty. I tried fixing the problem with just polishing but it was not enough. Since using the home and then polishing the chamber I’ve had zero issues.
Mark
Reviewed in the United States on October 13, 2023
It cleaned and smooth the revolver cylinders really nice.
Ashton
Reviewed in the United States on October 5, 2021
I had a TC Contender that had issues with cases sticking in the chamber after firing. I had tried a brass wire brush and numerous solvents and patches thinking it was dirty. No luck. I read about these on a forum and figured I'd give it a try. And let me tell you this little number fixed that problem right up. If I ever have issues again I know exactly what I'll be doing!
Recommended Products
$41.39
$ 20 .99 $20.99
$21.99
$ 10 .99 $10.99