Your cart is empty.
Your cart is empty.11
Customer
Reviewed in the United States on February 17, 2021
I measured the attenuation from 1 Hz through 60 MHz using a signal generator and oscilloscope. At frequencies below 20 MHz the attenuation is closer to 19.5 dB. It increases to 20 dB at frequencies between 20 and 40 MHz and then decreases to about 19 dB as the frequency increases to 60 MHz. It was good enough for my purposes.
jp314
Reviewed in the United States on June 17, 2020
only received 1 item, even though original picture shows 2 (since changed). Q&A also mentions 2 items.
R. Ross
Reviewed in the United States on January 2, 2019
I was looking for a 10x oscilloscope attenuator to use for measuring 15 to 40 Vrms AC devices and power supplies that are best hooked up with a hard-wire setup...not a 10x scope probe. Unfortunately, this attenuator only works as a 10x attenuator at radio frequencies...not down in the DC to audio-frequency range. Its totally dysfunctional at audio frequencies. What I found for my application is the Hantek 20:1 Passive Attenuator. It works great for my audio frequency needs.
Heinz Lackner
Reviewed in the United States on January 26, 2018
Work as advertised
Jeff K.
Reviewed in the United States on March 7, 2017
Good attenuator. Match to 50 ohms is OK but not amazing (S11 Would buy again, all things considered.
Terry913
Reviewed in the United States on May 9, 2016
Very good attenuators right on value at a fraction of list price.
D. Bishop
Reviewed in the United States on May 21, 2015
You can certainly buy much more expensive units, but I do not see any difference in the quality for what I do.
Henry Halladay
Reviewed in the United States on April 29, 2015
Works great with my oscilloscope. Arrived when promised and was exactly as described. Great purchase experience.
Recommended Products
