Your cart is empty.
Your cart is empty.Product Description
M.2 SSD NVME/SATA External Case
*Please note that this product is not applicable to B key NGFF/SATA.
Transfer rate:
NVMe protocol: 10Gbps SATA protocol: 5Gbps
Material:
Aluminum alloy
Supported OS:
Windows 11/10/8/7/Mac OS/Linux
Multi-OS, Windows, Mac OS, Linux, Android
Output ports:
USB3.1 GEN2 USB Type-C
Supported sizes:
2230/2242/2260/2280mm
UASP and TRIM functions are provided.
Equipped with High-performance Chip
The RTL9210B chip enables stable data transfer and can reach a transfer rate of 10 Gbps! (For NVME)
The external output port is USB3.1 GEN2 USB Type-C, which improves read/write efficiency for large amounts of data and accelerates the transfer of large files.
Compatible OS
Compatible with Windows 11/10/8/7/Mac OS/Linux systems. Supports Multi-OS, Windows, Mac OS, Linux, Android; compatible with PC, Smartphone, PC, Smart TV, Intelligent Router, PS4, etc.
Two Cables Included
USB Type-A to Type-C and USB Type-C to Type-C data cable (0.5m).
Easy to install and disassemble; easy to replace hard disks.
Equipped with LED Indicators
Equipped with LED indicators to monitor hard disk operating status.
Handling precautions:
1. If you use a new SSD, you need to partition it.
2. Due to the nature of SSD and aluminum has high thermal conductivity, the surface may become hot during use. Please be careful when touching directly.
3. The m.2 external SSD case is best connected to the USB port on the back of the desktop.
4. The drive speed itself is different, so it depends on the OS and drive you are using.
5. When removing the hard drive, do the removal on your PC before removing it from your PC. Be aware that forceful removal of hard disk cases or hard disks can result in data loss and hard disk corruption.
6. The rubber clasp in the case is easy to break, so you can not push this part when installing the SSD.
SnafuBE
Reviewed in Canada on January 4, 2025
Like that there are two different cord connections and is easily portable. Easily cloned drive without issues. Did not test speed but the drive worked fast enough.
Ash
Reviewed in Canada on January 17, 2025
This product is complete and very well-designed, which makes it too easy to work with
Customer
Reviewed in the United States on September 22, 2024
I bought this to retrieve files off the 2242 SSD on my dead Lenovo Thinkpad. Worked out perfectly. My only wish is that the pegs for the smaller size drives were easier to insert in the enclosure (this is probably where I spent most of my time in the process). But once that was done, worked like a charm. Not sure how long it will last since I'm really only using it for a one-time purpose, but well worth the money for that purpose.
MaxS
Reviewed in the United States on September 21, 2024
It's just an enclosure, but it does exactly what it needs to do, and does it well.It doesn't get very hot at all.Its a toolless case, and the tray/drive area can slide back in either way.It comes with two cables (which I personally prefer to a cable and an adapter).Speeds are as expected for usb 3.2It support SATA and NVME, with all the different key types, and sizes (2230-2280).Price is on the lower end of the spectrum.These all seem like they should be standard for an M.2 enclosure, but many models fail at keeping it simple. They require a tool, don't support all the various types of drives, or aren't well designed.Would, and probably will, buy again
Charles D Wathen
Reviewed in the United States on June 7, 2024
I've purchased these before and never had an issue. I recently purchased 5 more. Two of the units don't work because the USB/Type C cables are defective. I confirmed this by swapping out the cables with the other 3 units that work fine. I'm hoping the MFG can send me 2 new USB/Type C cables as replacement.If I get the replacement cables, I will change my review to 5 stars.
Lloyd E. Sponenburgh
Reviewed in the United States on June 17, 2024
When I first received this, it worked fine, but had a purely mechanical defect in the assembly. They very politely and quickly replaced it. I am quite happy.It's easy to use with no 'setups' required. Just plug it in an 'go'. It's also small enough to carry in your shirt pocket with barely a bulge! It even comes with a spare chip-holder clip, in case the first one gets damaged or worn out. It also has two different USB cords to fit whatever you need. Nice product!I'd buy this again.
David Nuncio
Reviewed in Mexico on August 26, 2022
No se comporta como un dispositivo USB3.1 ni USB 3.0. baja velocidad de 43 MB/s.
Jorge
Reviewed in Mexico on November 5, 2022
Fácil de instalar,resistente y practico
Jason777
Reviewed in the United States on March 11, 2021
This enclosure is easy to use and works about as expected. I would not use it to swap drives in and out of more than a couple of times because the sliding latches are plastic. The cooling fin area appears to be the only metal on the enclosure.I tested the speeds on 3 different systems, all with a Silicon Power 2TB TLC NVMe SSD. Transfer speeds of the SSD installed directly on the Z370 motherboard were approx 2500 MB/s. All systems were running Linux Mint and hdparm was used to measure read speeds. Both type A and type C connections were tested for reading and no difference in speed was noted between them. The write speed was measured with nemo during the transfer of approx 900GB of mixed size files from an onboard NVMe SSD. All tests were done on USB 3.2 gen2 connections with the exception of the I7 system which was additionally tested with USB 3.2 gen1 (also known as USB 3.0 and USB 3.1 gen1),Results:Asrock Z370 Extreme4I7-8700KRead USB gen1=438 MB/sRead USB gen2=980 MB/sAsrock B450 Pro4Ryzen 5 3600Read USB gen2=935 MB/sAsrock B450 Pro4Ryzen 3 3200GRead USB gen2=935 MB/sWrite USB gen2=935 MB/sLinux did not report temperature for this drive. Due to the lack of temperature monitoring I removed the adapter card/drive from the enclosure and used a 120mm case fan to ensure the drive stayed cool during the large write and there was no throttling noticed. I'm not convinced that this enclosure would keep the drive cool during really large writes but it may, please check other reviews regarding temps.
Kman
Reviewed in the United States on February 4, 2021
After upgrading my main PC nvme drive, I was left with an extra 500gb gen 3 nvme drive.Wanted an enclosure just to keep the drive safe and that I could use to back up random stuff or to clone my main drive. After looking through many usb 3.1 enclosures, I found this one. The price seem right, but the best feature is that it uses the Realtek RTL9210 chipset. This is the best chipset to use on external nvme enclosures. The other chips available from other manufacturers have issues and run very hot. This chipset also gives you the option to use nvme or ssd m2 drives, which you have to pay more for that feature on other chips.This tool less case is very easy to setup and I was ready to go in 2 minutes.After plugging the drive into the USB C port in the back of my pc, I was getting max speeds of 1000 MB/s reads and writes. Also I tested file copy to see if I would get any slowdowns. I was able to copy a single 50 gig file in a couple of minutes with no slowdowns. Then I copied a 166 gig folder with many files in it and I was extremely surprised that it copied the whole folder in about 6 minutes and the drive did not slowed down once. You can see the transfer rate on the picture attached. You can see that there are no significant dips or slowdowns. Also you can see the screenshot of crystalmark speeds showing the 1000 MB/s rates.I was also able to plug in the case into my Note 20 Ultra and I was able to see the drive and copy files into it.Now, after the benchmarks and tests the case got very warm. It would have been perfect if this case would be metal. I really dont see the point of having the heat pad in the package if the enclosure it plastic.This enclosure does exactly what is suppose to and does it well. Like a previous reviewer stated, I would not use this enclosure to keep the drive plugged in all the time. I would use it just for backing up data or moving files.ANd if you want to get a really good nvme drive , I would recommend the INLAND PREMIUM nvme drives, which is the one I have on this enclosure at the moment.
Daniel O.
Reviewed in Singapore on February 22, 2021
Heat sink works as intended
Recommended Products
$189.99
$ 90 .99 $90.99