Your cart is empty.
Your cart is empty.Product Description
Dynofit 2" Rear Lift Blocks Kit
Fit for 1999-2010 Ford F250 SRW & F350 SRW
Incompatible Models:
- 1) F350 DRW with 4-inch Dana 80 Axle 2
- Tips: SRW = Single Rear-Wheel Truck, DRW = Dually Rear-Wheel Truck
- 2) Factory helper spring-equipped vehicles
*If the U-BOLT is too long, you can cut off part of it until it fits your car
Leon
Reviewed in the United States on February 19, 2025
East installation, I'm not too mechanical incline but was easy and smooth installation
Roberto
Reviewed in the United States on September 29, 2024
💯
Robert clifford
Reviewed in the United States on July 19, 2024
Despite it saying that it will fit my truck for 2021 F350 tremor in fact, the U-boats are actually too short the 2 inch risers are definitely built beefy, but without the U-boats it is completely useless. I was passed my 30 day mark when I went to install, therefore I could not return
Joey
Reviewed in the United States on May 9, 2024
These added a nice lift to the back of my truck. Install was fairly straightforward. Going to have to cut the excess bolts though. They hand down way too low beneath the bottom of the truck.
Roger
Reviewed in the United States on December 14, 2023
I rate a four because the product quality is good, just they don’t give enough specifications to let you know the bolt size. The 2” block is perfect. They have the taper to keep the drive shaft aligned (other brands don’t have a taper, especially cast iron ones). The bolts are 16” long with 6” of thread. I could deal with cutting them but there is not enough thread. I had to buy 12” bolts that fit perfectly. They cost me an extra $100. Measure before you buy. These went on a 2000 E350 van, 4:10 axle that already had an additional leaf spring installed. Had a shop install them for $325 in three hours. Well worth the cost and time saved and bruised knuckles. Final product looks great. For some reason it added 1/2” to the front also. Don’t know why.
Night Hunter
Reviewed in the United States on January 6, 2023
Can easily lose 2 inches on a stock ford f250. Cut them off to use a deepwell socket to tighten. Double check before installing because its easier to cut before you install. Otherwise everything fits good. Blocks are tapered to maintain pinion angle.
John McAfee
Reviewed in the United States on April 21, 2023
Did a rear spring swap on my 04 Excursion. Had to cut the U bolts . I ordered this kit and it was great the blocks had the right angle on them and the bolts are top notch. Really good kit. Well worth the money.
Aaron
Reviewed in the United States on June 8, 2022
I added a 2" blosk to the rear, there was still 5" i cut off after install. They will fit a 6" block lift easy or less. Exactly as described.
Recommended Products
$209.99
$ 99 .00 $99.00
$21.98
$ 9 .99 $9.99