Your cart is empty.
Your cart is empty.Inch and metric blank in drill indexes (Vermont Gage only) Indexes come with precision ground Jobbers length blanks ready for the cutter grinder! All H.S.S. blanks are heat treated to 62/64 Rc and marked with size. When you need a set of custom cutting tools and you want to make them quickly and cost effectively, use Vermont Gage drill and reamer blank sets. There is simply no easier, better, or quicker way to make quality cutting tools. * (-.0002 or -.005mm) tolerance. * Inch and metric diametric sizes * High speed tool Steel: 62/64 Rc * Jobber lengths * 10 microinch finish or better * Within .0001 round * Within .001 straight * Marked with size * Packaged in drill index MEDA Brand tolerance: +.0000 / -.0002" Vermont Gage tolerance: -.0002" or +.005mm)
Jessie
Reviewed in the United States on March 7, 2016
I should have looked not at the picture but looked up what wire gauge #61-80 actually is. These are sized from ultra-microscopic to merely microscopic. Syringe needles are made from thicker tubes than these drill blanks. Not what I was hoping for, and I'm stuck with an unreturnable item that cost far too much.
Tim
Reviewed in the United States on February 17, 2016
Smallthey come in good condition. clean, organized and ready for use. but are far to small for any of my uses. then again I didn't research this well enough before I bought it. but for its cost and what I got I regret it.
Recommended Products
