Your cart is empty.
Your cart is empty.Axle shaft damaged or bearings worn out? This axle shaft directly replaces the original equipment on certain vehicles, complete with all necessary application-specific installation components. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Ford Ranger: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009]
Martin Forget
Reviewed in the United States on February 17, 2024
Everything fits perfect.
Harrison Okabe
Reviewed in the United States on April 28, 2024
Fits perfectly
Sean Clemmons
Reviewed in the United States on March 9, 2022
Used oversized nuts as spacers to get the studs in. Held one end with pliers then tightened the lug nuts down with an impact wrench to pull them into place.
ranger bill
Reviewed in the United States on October 15, 2022
Worked perfectly on my limited slip 2wd 2002 Ranger with 7.5 inch axle
miriam fedorchak
Reviewed in the United States on June 13, 2021
Perfect fit. Put 10k miles on it. So far no problem.
William brace
Reviewed in the United States on February 3, 2021
Every time I turn a corner it grinds it should never grind
Michael W.
Reviewed in the United States on August 23, 2020
Repair was pretty easy right-in right-out, did have to use a grinder on the end to get the PIN to fit back in other than that perfect super tight tolerances.
Ty Stanton
Reviewed in the United States on January 16, 2020
The axle was just what I needed. The bearing was A name brand and fit great. The seal also looked excellent. I recommend using A driver that is the correct size for installing the bearing. The race could be easily damaged if you try to install it with A punch. I turned one out of plastic. Hard wood would also work. The best way to install the wheel studs is with A hydraulic press before installing the axle.
Recommended Products
$125.95
$ 54 .99 $54.99