Your cart is empty.
Your cart is empty.
Specification:
Colour: Red
Material: 45# Steel + Rubber
Size: 45*13cm
Type: Expander Tool
Working pressure: 5-8 bar
Maximum air pressure: 8 bar
Air Inlet Size: 1/4 inch
John John
Reviewed in the United Kingdom on February 27, 2025
To small for a Transit van's CV joints, need something bigger...It did the job but not with out a good old fight, it stretched the boot okay but only just wide enough to get it over the CV joint with a good push had to use alot of lubrication to slide it off onto the cv because it wouldnt close enough to get it offreturned for refund .
Michael tierney
Reviewed in the United Kingdom on February 18, 2025
On time
Alberto Gustavo Marquardt
Reviewed in Brazil on February 17, 2025
Ótima ferramenta, de muita qualidade.
Steve
Reviewed in the United States on September 8, 2024
Came with a varity of fittings, worked perfectly on my 2011 Avalanche boots. A little oil on the prongs helps get the boot off. Make sure you use enough pressure and get the correct boots for this type of install. Flexx Boot FB3001 Large Shaft worked great. Would definitely buy again.
Derek B
Reviewed in Canada on September 21, 2024
leaked heavily at "full" stretch, which wasn't enough to actually fit over oem cv stub. so it was pretty much useless. bought it to save time, was easier/faster to disassemble cv and repair it than try to get it to work. may be alright for thinner cv boots but thicker ones just fall off halfway through extension.
CoD4 Legend
Reviewed in the United States on September 1, 2024
As long as you have a decent compressor, this will stretch CV axle boots if you use the right brand, some brands are tougher than others and will not stretch, but others definitely will
Daniel
Reviewed in the United States on August 22, 2024
Arrived as expected , worked well and made well !
Jorge Garcia Ruiz
Reviewed in the United States on December 31, 2024
Perfecto una recomendación usa grasa oh como las conoces en la parte de que cambias así se desliza más fácil una compresora de 1.5 gallón le trabaja bien 👍
NickW
Reviewed in the United States on December 31, 2024
I bought this item to put thick rubber grips on. I ran it with 125 pounds of air and it worked pretty well. I had to help it open the last few centimeters. This wasn’t a problem. It’s pretty well made and the fingers dont bend. Dont know how it would do on a CV boot, but the grips are about the same thickness so it should work.
GD
Reviewed in the United States on December 24, 2024
Could not expand boot and had parts missing on it, waste of resources.
Nicole
Reviewed in the United States on November 2, 2024
Did not work on Integra CV Boots, at 135psi. Tried both directions with no luck even with heating the boots in boiling water and heat gun. .
MR.B
Reviewed in the United Kingdom on October 29, 2024
Far superior to using a cone and it comes with different air fittings
Bedubs
Reviewed in the United States on October 17, 2024
I used it for my ATV CV boots, since they are smaller than most automotive boots, it was a bit large for the job but worked. Had to dip the boots in hot water to soften the rubber enough to allow them to expand.
Recommended Products
