Your cart is empty.
Your cart is empty.MBar
Reviewed in the United States on February 6, 2025
I sent one pair back because Rivet was broken and second set seems fine.
Michael Smith
Reviewed in the United States on February 6, 2025
Worked as described
Seahawks4life
Reviewed in the United States on February 27, 2025
These are nice and very helpful when trying to hold two wires together to solder. I would've bought one sooner if I had known. Working on automobiles trying to solder is a pain because you need a second person to hold the two wires together. This plier works great for that.
Randy Vigallon
Reviewed in the United States on February 12, 2024
OK tool, Really not sure I needed it. It does what it says it does, holds two pieces of wire. I don't understand the "lock" lever, it did not come with any instructions. Without touching the "lock" you can continue to squeeze the tool and the device continues to move. The lock lever only allows you to open the jaws? It is well built.
Searay 1
Reviewed in the United States on December 7, 2024
I like these, good quality and make soldering alot easier with these holding your wire in position.
Jim Cook
Reviewed in the United States on December 6, 2024
Worked perfectly, didn’t need clamp or ect to hold wires together to solder. Highly recommend
Mark Reeder
Reviewed in the United States on November 4, 2024
Great time saver, easy to use and works great
Erik H.
Reviewed in the United States on January 26, 2024
I tested these on 14 AWG wire, which might be more than it is designed for. The wire latches cannot hold the wire hard enough, so when you close them the wire strands will not mesh, but instead it just pushes the wire out of the latches. This might not be the case of thinner gauge wire. What would be nice is if the latches were replaced with thumb screws to hold the wire in place. Works better if you just do a twisted splice as opposed to meshing the strands.
JavierAM
Reviewed in Mexico on December 7, 2023
Buena herramienta, de gran ayuda
Recommended Products