Your cart is empty.
Your cart is empty.Get table saw-like cuts without the cost when you use the BORA NGX T-Square with your NGX Clamp Edge System.
Ben W.
Reviewed in the United States on June 20, 2024
The perfect addition.
Gregory J. Weldon
Reviewed in the United States on December 16, 2024
nice and sturdy
Tim
Reviewed in the United States on November 2, 2024
,
Polo
Reviewed in the United States on February 14, 2022
Easy to attach and use. However, it shipped without the support finger which holds the piece in place when it the L position. In that position without it the entire square is useless. I contacted the manufacturer, they shipped missing part.
Gustavo Villalobos
Reviewed in the United States on April 9, 2021
Easy to assembly but connection is not even making difficult to pass the circular saw from one side to the other. Not accurate at all. Flimsy. I do not recommend.
Chin Heng Neo
Reviewed in Singapore on April 5, 2021
-
Normand Matte
Reviewed in Canada on September 2, 2020
Doesn’t align at accurate 90. Probably because it arrived bent. It’s gotten to the point that I can’t be bothered sending items back.
Steve R.
Reviewed in the United States on September 15, 2020
I use this for cutting large sheet goods along with NGX clamp edge. Works very well and is accurate. clamping on both sides make it very secure. Does not flex or give as I'm cutting and cuts and straight and accurate.
ds5150
Reviewed in the United States on December 6, 2020
Usually you'll get what you pay for. Sadly, this line of tools feels cheap and fragile, not what you look for in shop tools. I'm afraid to take it onto a job for fear of it being damaged or worse.
Kaw1011
Reviewed in the United States on December 3, 2020
it's not perfectly accurate but it works fine for breaking down sheet goods to be re-sawn later on a table saw.
Recommended Products
$36.99
$ 18 .99 $18.99