Your cart is empty.
Your cart is empty.4.1 out of 5 stars
- #138,750 in Industrial & Scientific (See Top 100 in Industrial & Scientific)
- #30 in 3D Printer Controllers
【TMC2208 V3.0 Features】:
Working Mode: DIR Step
Microplver: 1/256
Microplyer Mode: Up to 256
Driver Current: Up to 2A
Input Voltage: 4.75-35VDC
Logical Voltage: 3.3V-5V
Decibel:
RDSON: ≤0.3Q
Stealthchop(quiet): Yes
Spreadcyle: Yes
Motor Phase Current: 1.2A RMS, 2.0A Peak
【UART Working Mode】:
Note: the factory tmc2208-v3.0 has two modes of STEP/DIR and UART, customers can choose according to their needs.
Users who purchase the STEP/DIR mode driver need to perform the following hardware operations on the driver module before wiring.
The user who purchases the UART mode driver does not need to perform any soldering operation.
【The Benefits of UART Mode】:
Motor current can be set arbitrarily by firmware.
Micro-steps can be set arbitrarily by firmware (up to 256 actual micro-steps).
The actual and interpolated microsteps can be combined to achieve maximum torque.
Firmware can dynamically switch stepper motors between stealthChop2 and spreadCycle modes through UART.
【Attention】:
Make sure to do a good job in heat dissipation (heat sink + heat dissipation fan) before driving to prevent abnormal operation of the drive.
If you encounter problems in use, welcome to contact us, we will be answer to you ASAP. If you have any good comments or suggestions on our products, please tell us, we will carefully consider your comments or Suggestions. Thank you for choosing BIGTREETECH products.
Susan hale
Reviewed in the United States on May 15, 2024
3 out of 4 drivers were dead on arrival
Martin T
Reviewed in the United States on September 14, 2023
The media could not be loaded.
Joel
Reviewed in the United States on August 24, 2023
bought this cause it claimed to already be configured for UART mode 3, but it isn't. The included headers make the necessary required soldering extra inconvenient
daniel
Reviewed in Canada on November 11, 2023
Wicked little drivers, cured my diseased Y stepping issues. Excellent quality, very nice to look at (even though you won't see them, you'll know they're there 🤣) and best of all, they work amazingly. 10/10, love this company and their products.
nathan e corkwell
Reviewed in the United States on December 31, 2022
no problems they worked great.
Kirk Montez
Reviewed in the United States on September 4, 2020
I ordered UART mode to avoid having to do additional soldering, but I still received the standalone version. The soldering pads are very tiny. Hopefully my hands will be steady enough to solder them without breaking it.I understand mix ups happen, but this is annoying.
Maya D.
Reviewed in the United States on September 22, 2020
Best price for product
Carol
Reviewed in the United States on June 12, 2020
From the description, it's hard to tell whether these come in "legacy" mode or "UART" mode. The manual says that they come both ways from the factory and that the UART mode ones do not need J2 configured for UART mode. These come without J2 configured! BigTree-Tech expects the buyer to install the .4mm solder blob that's partially obscured by the preinstalled pin headers.
Chris Cicle
Reviewed in the United States on February 17, 2020
Always wanted to upgrade to the Tmc drivers. Bought a SKR 1.3 from Bigtreetech and never looked back! Print quality is excellent, and the sound level is reduced. I have to look sometimes to make sure the printer is still printing. Will use these driver sticks again for future upgrades.
Recommended Products
