Your cart is empty.
Your cart is empty.
BIGTREETECH CB1 is an alternative to Raspberry-Pi CM4. The same BTB header as the Raspberry-Pi CM4; CB1 combined with Pi4B, the performance is almost close to the Raspberry-Pi 3B, and can be an alternative to the Raspberry-Pi 3B.
Feature：
1. CPU: Allwinner H616, Quad-core Cortex-A53 @1.5GHz
2. GPU: Mali G31 MP2, support OpenGL3.2
3. RAM: 512MB/1GB DDR3L SDRAM
4. Display: HDMI2.0A interface, support 4K display
5. USB 2.0 port
6. 100M Ethernet + 100M WiFi
7. The same BTB header as the Raspberry-Pi CM4
8.Compatible with Pi4B adapter, Manta M4P, Manta M5P, Manta M8P 3D Printer motherboard
Richard Middleditch
Reviewed in the United States on September 20, 2024
I been trying for days now to connect this thong to my manta m8p and evrytime i have followed the instructions to get the address of the board with the ls /dev/serial/by-id/* i get the same eroor of the directory not being found i have spent hour trawling the internet redit klipper forums and ant get a soultion and none of them have worked so save your time and dont buy this its wasted too much of my time
kenneth rood
Reviewed in the United States on July 21, 2024
stopped working within 2 days
michrech
Reviewed in the United States on July 1, 2023
Added this, along with their Pi4B carrier, to my TwoTrees SP3 printer for Octoprint (which I may eventually convert to Klipper, if I keep the printer). Works perfectly, though getting Octoprint set up is not as easy as installing on a Pi, as there isn't a pre-made image to flash (that I'm aware of). It's handled every print I've thrown at it, including a super-complex square tissue box cover that has a rather intricate design on its outer skin, without missing a beat.If you're looking to add Octoprint / Klipper to your printer and can't get a Pi, don't hesitate to try this alternative!
Harley B
Reviewed in the United States on June 8, 2023
Works well for when you're needing something that can run Klipper but BE AWARE THE GPIO PINS ARE LABELED DIFFERENTLY. Standard Raspberry Pi GPIO pin labels will not work on it. You'll have to find the proper pin identifications if you're going to run things like CPAP while using this board. Otherwise it runs klipper fine. I've run into no issues with buggy wifi or weird behavior. It's gotten my Voron 2.4 Running without a hitch so far.
Cameron Smith
Reviewed in the United States on May 3, 2023
Needed to replace my cb1 as mine went out. Shipped quick and in good shape, all items was inside. Would buy again if needed in future
Denny Sawyer
Reviewed in the United States on October 25, 2023
Using this board with my Manta E3EZ main board, and it's an excellent alternative to an external Raspberry Pi. It installs easily, directly on the main board, so you don't need an external power supply, and it has WiFi built in, unlike most other Pi alternatives. My biggest complaint so far is that the little rubber duck was squashed.
MasterSe7en
Reviewed in the United States on April 13, 2023
Running my ender 3 v2 with klipper with this and I love it, is perfect no pi setup externally near printer
Recommended Products
