Your cart is empty.
Your cart is empty.Product Description
Please Note:
1.Fits all window sizes up to 55"x36" - If your window frame measures 55" x36"or less , then this adjustable magnetic window screen will be the perfect fit! Measure your window before ordering to be sure our screen will fit.
2.The DIY window screen package includes one piece of high quality mesh, one roll of magnetic tape, one roll of plastic strip, one bag of accessories and an instruction manual, ensure quick and easy installation.
3.Please read instructions before installation, it will help you install the window screen easy and quickly.
4.To ensure tight installation, please press the frame and corner hard so the glue on both sides could go through the mesh and cling together.
5.Please straighten the magnetic tape and plastic strip before installation to prevent the edges from lifting up.
Why Choose DIY Magnetic Window Screen:
1.Fits most windows: Single/Double hung windows, sliding windows, casement windows, curved/balcony windows, etc.
2.Can be used for windows made of wood, steel, aluminum, UPVC, etc.
3.Easy to install. A magnetic window screen can be installed in 15 minutes. Omit time to measure and save money from custom-made window screens.
4.Use magnet to firmly seal windows.
5.No screws or drilling. Keep windows’ original structure.
6.Dedicated industrial adhesive, high viscosity and long lasting. No sticky left after peeling.
7.Can be used either indoor or outdoor. High quality material suitable for all weather conditions.
8.Screen frame as narrow as 1/2” to fit even the smallest area available.
Installation Steps:
1. Clean the window Frame
2. Prepare the magnetic strip to attache to the window frame.peel of the protective film and press it onto the window frame.
3. Lay and attract the rest of the magnetic strips on top. Note the line direction on the magnet.
4. Cut off the execessive magnetic strip.
5. Pell of the protective film of the top magnetic strips. So the adhesive is ready for mesh.
6. Lay the mesh on.
7. Prepare the plastic strip to lay on top for the mesh. Peel the protective film and press it onto the mesh.
8.Put on the corners, Top plastic strip slide into the corner.
9.Cut off the excessive mesh.
10. Put on the wind-clips by peeling off the protective film. Then attach it to the bottom magnetic strip surface. The screen layer (magnetic strip 2, mesh, plastic strip) will be secured inside of hte clip.
Bumbles Momma
Reviewed in the United States on February 23, 2025
Easy to install, works perfectly, looks great, perfect fit.
Terence White
Reviewed in the United States on February 16, 2025
Wow ! Im in the D R, had issues with flies all day. Installed, on doors and windows 😊, best thing i could have done, no more fly traps and constant spraying !
janet mcleod
Reviewed in Canada on August 27, 2024
Easy to put on the mattress. To protect the mattress.
Lori
Reviewed in Canada on July 19, 2024
The media could not be loaded.
Vanessa
Reviewed in Canada on July 7, 2023
Took a bit to get it up on the window but got it. I am not a handy person but instructions were easy to follow, so if I can do it, anyone can.I got it for my son's window as he didn't have a window screen and he's a happy boy as he can now have his window open again and not worry about hornets coming in anymore, as he's allergic to their sting. So thank you!
SB
Reviewed in Canada on July 10, 2023
If adhesive was better this product is really good.
Eduardo Espinoza
Reviewed in the United States on February 9, 2021
Would not recommend. It installed just fine. I questioned the quality of materials and durability and soon as I opened the package. Followed the detailed instructions but as I was putting it together I knew it was going to cause issues but I went with it hoping for the best.Adhesive is not strong enough to hold up. After a few hours I heard it colapse off of the window. I pulled the formed frame off the magnetic strip, layer it flat and put some heavy books to weigh it down and hopefully seal it. After a day I figured it was going to be as good as it would get so I put it back into place on the magnetic strip and again, collapsed after a few hours. It was a small window as well, so I can’t imagine what it would be like to try and do a larger window.Sadly will have to find something better.
Andrea L Scheffler
Reviewed in Canada on April 27, 2021
For what it is and the price point, this is a decent product. It is NOT a ten minute install. The concept of it is really simple but it is quite fiddly to put together. My biggest problem with it was the mesh screen, which is not square cut so lining it up to the window initially failed. I guess the point is to place it on with a lot of overshoot and trim all four sides after but the trim is a little difficult once it's stuck on the magnet strip so I was hoping to just trim off two edges. I also have a wide two-part window that this should have covered, but the screen piece was the wrong proportion to do in one piece, so it is in two pieces sort of untethered down the central frame. I plan to solve that with a bit of extra magnet strip from the craft shop sometime. The screen is soft and stretchy as well so getting it flat is virtually impossible. Adhesion so far seems fine but I took an extra step to help this out after reading lots of people had issues with the corners peeling up from being shipped as a roll. When I got the package, I unrolled and rerolled the magnet and frame strips in the opposite direction to take some of the ben out. Then I measured and cut the strips to fit my window, gathered them all up, and put them flat on the floor under a pile of heavy books for a day. This flattened them out perfectly and there has been no bounceback so far.Overall, it isn't a super attractive solution, but I needed something to keep my cat in mostly. If you have a pet that is an escape artist, this is maybe not the solution, but they are surprisingly sturdy, even with the middle section loose and if he were to tumble against it, he would bounce off for sure. Easy to pull up the corner to access the window latch to open or close. It'll keep the bugs out too. Good solution for a quick n dirty scenario where looks aren't the top priority or you need something you can take on and off seasonally.
Mr.Sharpy
Reviewed in the United States on March 9, 2020
So the same story probably goes for everyone, "We needed window screens to keep dust out"I bought these screens over 1 month ago, they have been in place for over 2 weeks and this is my review to shed some light to future buyers before buying.Pros: Its a window screen, it does the job, and its fairly simple and adjustable.But this review is specifically for the struggles I had with this product, starting with the installation.-- Installation -- : It seems rather easy on paper, but unless your window is in the middle of a wall without any complicated surroundings, then the installation is not gonna be easy, In my particular case my windows are at the corners of my room and I have furniture in front, installing these as 1 guy was not simple, specially due to the adhesive problem I will be talking about later. The instruction that come with the product are not clear enough, I had to look up a review here to understand completely how the installation works. For anyone struggling or curious:- You first place the magnets on the wall with the adhesive part.- Then place same sized magnet strips over the magnet strips that are already adhesive to the wall.-- Adhesive problem --Part of the installation requires you to place the Screen material over the adhesives that the magnetic strips bring with them. The problem is that these Adhesives do not hold alone, this was my main issue while installing these, it felt impossible to hold the screen with just the adhesives while I was trying to place the plastic strips at the end.I recommend having someone there to help you hold the screens up from falling while you do the final steps of installation.After my screens were installed, you can see from the pictures that the adhesives don't last long, there work great sticking to a flat dry surface, but holding the screen and the strips it just doesn't work as well, I had to use double face tape to give it an extra grip and make the strips and screen stay pasted together. Kinda defeats the purpose if it doesn't hold itself on its own.EDIT!! (3 months later)The glue that comes with the magnetic/plastic strips does not hold well, I've had to add extra support to them with double sided tape.
Buddha Lover
Reviewed in the United States on June 21, 2019
After I found a yellow jacket in my bed one night and a bat flying around my room another it was time to find a screen for my bedroom! The only problem is all of my windows are push-out casement windows and no traditional screen would work. I was nervous about buying based on 1) the adhesion, would it damage my old growth redwood trim and 2) would the brown plastic look super tacky against my wood trim? As for the adhesion damaging my trim, only time will tell as it's only been up a week and I haven't needed to remove it. But I was super happy at how well the plastic trim DIDN'T look tacky, it actually blends in quite well! (See pic).Minor cons: 1. It did not take 10 mins to install! I am pretty handy and it took about 45 from start to finish. My window was pretty big though.2. The outer trim bent and discolored (see other pic) when I was fitting it into the corner piece.3. Trimming the excess screen wasn't easy to do cleanly, even with a box cutter. It left exposed jagged bits along the sides in some places.Bottom line, I recommend this product, it does the job and it was easy to install!
HeyLisa99
Reviewed in the United States on May 13, 2019
So $35.00 seemed a lot for one screen (I have 3 windows that need screens) so I decided to give it a try to see if it worked. The magnetic strip is 1/2" wide, which is exactly the width of my frame. I sanded the frame and wiped it clean to get a good grip. The magnets seem to be pretty magnet-y (screen stayed in place).The instructions were a little confusing at first (the print and illustrations are VERY tiny, and there's not much detail) but I figured it out eventually. It takes a little bit of trial and error to get the screen in place and taut (it's not perfect but it's good enough), but I was able to peel the screen off and re-position it successfully. The screen feels kind of floppy so I don't think I'll be removing it more than necessary. I put it up yesterday and I'm not touching it for two days to give the adhesive a chance to cure before I put any strain on it - I'll report back after I've lifted it up a couple of times.The most confusing part was putting the corner pieces on the screen - the instructions say to peel off the protective film and stick the corners into place on the plastic strip; however, there is no sticky tape on the backs of the corners, so there's nothing to hold the corners on. I bought some heavy duty double-sided tape to put inside the corner pieces, but it's kind of thick so it's not allowing the corners to fit tightly with the plastic strip. I feel like I'm missing something here, but the instructions are not clear enough for me to figure it out. I'm going to reach out to the manufacturer to see if the sticky tape is missing on my kit, and report back.Packaged well, arrived on time. On the whole, this is not a perfect solution, but it is a pretty good solution for weird old fashioned windows that need screens!
Recommended Products