Your cart is empty.
Your cart is empty. Specifications:
IR switch state: 3-8lux / F1.2 (IR light on)
IR switch control: CDS Auto control
Input voltage: DC 12V ± 10%
Lamp bead amount: F5 * 48 940nm
Infrared power: 4.6W
Infrared wavelengths: 940NM (No Red Exposure at Night)
Night vision distance: 10-30 meters
Input current: 12V 260mA
Output current: 260mA via infrared lamp beads
Light cup Angle: 90 degrees
Light cup size: Ф5mmx8.5mm
Adapter lens: 2.8 \ 3.6 \ 4mm \ 6mm
Lamp plate size: outer diameter 60mm, lens inner hole diameter 16.8mm
Adapter shell: 75 series waterproof camera
Note:
Manual measurement, with small error. Please check size in detail before purchase.
Real colors may slightly differ from the pictures, as it depends on specific monitor settings and light brightness.
We highly appreciate all customers opinions to improve the selling, also if anything you unsatisfied, please contact us for probable best solution.
Package Includes: 1Pcs
Rick Wilson
Reviewed in the United States on September 2, 2024
I purchased this to replace a burned-out module. I had to do some filing to make it fit my housing but managed. My camera outputs 12 VDC and is plug-compatible. Polarity was correct on my unit.The IR LEDs are indeed invisible to the naked eye. My smartphone detected the IR as a deep purple color. Output is sufficient for my application.
John
Reviewed in the United States on June 3, 2024
Does not work
Brett
Reviewed in the United States on June 23, 2024
X2, both inoperable.
Simon
Reviewed in the United States on February 10, 2022
Item didn't turn on and I tried to find out why.The illuminator comes with a CDS photocell (light sensor) and a small Molex socket to probe the Light Dependant Resistor value. The value was always zero, independent of environmental light. Why? Because the pins of the Molex connector were shorted. I tried to fix the falty solder job, but it turns out the pins are connected on the PCB itself. (see photos)I had to remove the entire light sensor in order to make the illuminator work, but now it doesn't switch off during the day. Terrible quality, zero quality control. :(
Jacob Mouring
Reviewed in the United States on June 21, 2021
I got this as a IR light for the quest 2 I wired it to a 9v and a switch and put it on my black VR shell it worked grate nice bite of light it puts out that the quest can see.
Kelly C.
Reviewed in the United States on May 27, 2021
This worked very well. The only thing that was wrong is the wire harness that comes with it has the positive/negative wires reversed. Also worth mentioning i thought mine was defective even though I knew the wires were reversed because I was covering up the light sensor with my fiber to see if the power supply i had would be sufficient and it wasn't powering on because you can't use your finger to block the light from the sensor, you have to use something like tape.That being said I have a 1st gen nest cam that the Ir light doesn't work on anymore hence this purchase and this is WAY brighter than the stock led's with the added benefit of not being able to see the low red flow from 850nm leds.
daniel
Reviewed in the United States on May 10, 2021
It works
sweater shopper
Reviewed in the United States on October 19, 2021
Bought this to work up-close with an near IR video camera. When powered there was a slight bump in the image from pitch black only. By comparison, using other near IR LEDs, the image would go from black to near saturation when the LED was powered. So it works... but not useful in this application.
Recommended Products
$103.20
$ 41 .99 $41.99