Your cart is empty.
Your cart is empty. Acrux7 Metal Deburring Blades Set for (diameter
Blades Features:
HSS high speed steel
45 degrees oblique angle
3.2mm blade diameter
It is easy to install blade by compressing the mounting head.
The installed blade could be flexibly 360 degree rotated.
It is sharp and easy for burr removing.
Please be careful and make it away from the kids.
Package Included:
10 Pack * Black 43mm Deburring Blades
Omadna
Reviewed in the United States on October 4, 2024
I got some from CNC Kitchen and then found these on Amazon. These are much cheaper and so far work well. The longer shank pieces are hard to get in corners etc .. I will post on longevity later if the aren't holding up.
JM
Reviewed in the United States on July 26, 2023
Knives are always good if recommend
Bryce
Reviewed in the United States on November 14, 2023
I debur close to 10000 feet of copper in various lengths per year and they work great.
Chuck
Reviewed in the United States on October 11, 2023
Did everything they said it would. Works well on plastic
Micah
Reviewed in the United States on May 30, 2022
I was using a much larger size cleaning plastic parts and had issues with stuttering cuts along edges .This smaller size is perfect.its much sharper and allows for lighter consistent cuts.
Primal00
Reviewed in the United States on June 19, 2021
I just purchased these blades for a test run and they come with a few issues. I usually buy through MSC but gave these a try... Well the coating on the outside surface of the blades is too thick for my swivel handle so I have to hit them with a grey wheel before using. They cut through plastic ok for a little while... But 304 SS and harder blade won't cut burrs.
Bowman90
Reviewed in the United States on November 3, 2020
I'm sure the product works fine, but it specifically says it's for holes less than 1.5mm (0.06"). I have a deburr tool with a hole that's 0.08" and it's too big to fit in the hole. I need replacement blades for my tool, because it's a great tool, but the blade broke. So I purchased these expecting to put in a blade and start deburring keyways again, but unfortunately as I stated, the shank is too big for the hole in my tool. When I took my calipers to them, they actually measure .120".
Samantha Hopkins
Reviewed in the United States on October 25, 2018
Work great. Just don’t drop your handle on the ground or the tips will snap off the blades.
Recommended Products
