Your cart is empty.
Your cart is empty.This 5-pack of brass sleeves allows the conversion of split shaft pots into solid shaft pots. The internal diameter is approximately 6mm.
C. Satterfield
Reviewed in the United States on March 3, 2024
if you use these sleeves on a split pot on your guitar, keep in mind that the inside of the knob you were going to put on them needs to be large enough to slip over them. It will be a matter of try the knobs first on the sleeves, and if the sleeves don’t work, then return them or keep them and try to find different knobs.
Holly R.
Reviewed in the United States on March 23, 2024
Nice product, I have a split shaft pot but a knob with a set screw so this was necessary for me
John Smith
Reviewed in the United States on March 1, 2024
They fit perfectly on my cts sized pots, I used witch top knobs for a split shaft pot, which require the smooth kinds, these adapters made them fit right in perfectly. They will bend/mold into shape making it a tight fit, so even if it’s a little loose, tightening the screw will make it fit perfectly fine.
Phil Dooley
Reviewed in the United States on December 4, 2024
Package came with sleeve crushed inside. Description says 5 sleeves but only 1 in package. Replacement also only had 1 in the package. ARRGH!
Lee
Reviewed in the United States on November 4, 2024
These fitting rings were needed to get my new guitar knobs to fit properly ,had issues with the knobs wobbling and just not fitting correctly ,and these fit the bill nicely!
Kevin
Reviewed in the United States on October 5, 2024
This is exactly what I needed for my guitar project but 4 of the 5 were smashed during shipping. They should ship these in a box not an envelope.
Kevin G.
Reviewed in the United States on April 4, 2024
These do the job perfectly. Good fit. Exactly what I needed
la
Reviewed in the United States on June 13, 2023
Used this to adapt a 6mm shaft for a 1/4 inch shaft knob and it worked perfectly. Comes in a small plastic bag and includes 5 adapters.
SteveB
Reviewed in the United Kingdom on October 30, 2020
I was worried about grub screw squashing the slot in split shaft - my solution was to shave down an ice lolly stick to put in the shaft slot before mounting the knob(s) - lovely job
Recommended Products
