Your cart is empty.
Your cart is empty.Product Description
1/8“ Cutting Radius
3/16”Cutting Radius
1/4“ Cutting Radius
5/16” Cutting Radius
Jonathan Lauber
Reviewed in the United States on February 22, 2025
This is a cheap set of bits. It works well enough for a project. Even if they dull after one use, then you have gotten your money's worth out of them.
TCru
Reviewed in the United States on February 20, 2025
Arrived as scheduled, and well packed.Very crisp machine work, included xtra bearings. I used only two sizes so far but very happy.Recommended, 5 stars...
Tina
Reviewed in the United States on February 17, 2025
I used the 5/16" to bevel the edge of a piece of 5/4" pressure treated that I replaced on the end of my deck's handrail. It worked as advertised, and left a fairly smooth edge with little sanding needed.
Charlie C.
Reviewed in the United States on February 15, 2025
This is an inexpensive set of round-over 1/4" router bits. There are no markings that I could see on the individual bits indicating the radius size. The 'anti-rust' paint is a bit grimy, but the real problem is that on one of the bits, the bearing is tipped - not 90 deg to the shaft. This indicates a poor quality control. When using one of the bits, I noticed that the resulting cut had a 'ridge' at the bearing end of the cut probably due to the bearing being slightly smaller than the cutting blade. Yeah, I'll keep these in the shop for rough construction of benches and work tops but won't be using them for anything where I want a professional look in the final product. But the price is attractive (and you get what you pay for)!
Scott
Reviewed in the United States on February 14, 2025
Out of the package these bits are sharp and make easy work of cutting through the soft woods I have tried them on. Have only used it long enough to try it out so far, but no issues and it makes clean cuts. At like $2.50 a bit these are an amazing bargain.
SavvyBuyer
Reviewed in the United States on January 4, 2025
Roundover router bits are arguably the most frequently used bit in a woodworking shop, especially the 1/8 radius roundover. It is used very often for knocking the edge of sharp corners.This set comes with 4 bits from 1/8" radius to 5/16" in increments of 1/16". This is a good range in my opinion. They are made of C2 carbide which is wear and heat resistant but not as good as C3 carbide would be.I confirmed the specifications with a caliper and found everything in tolerance. The photo is of the shaft being shy of 1/4" in diameter by 2 thousandths for ease of slipping into the collet. The bearings were free-wheeling and smooth. The radii are a little harder to confirm, however, measuring up from either corner and across to the opposite corner at 90 degrees gave acceptable readings.You are getting 4 roundover bits with bearings for under $11 so that is a very competitive price point. Having said that, I don't expect these to stay sharp for years, but they run true, didn't burn and will see much use in my shop for as long as they last.
Larry Clifford
Reviewed in the United States on January 28, 2025
Very good
Kurt Redner
Reviewed in the United States on January 18, 2025
Very clean cuts, rounded edges as needed and worked well - 10 doors done and still sharp.
Recommended Products