Your cart is empty.
Your cart is empty.Improve your CNC cutting abilities with the Whiteside CNC Spoilboard Surfacing Router Bit. This 1/2" shank bit clears the surface of your Spoilboard, creating a base surface that is perpendicular to the router motor .Once you add your planed project material, you are ensured an accurate cut. This CNC bit can also be used to flatten live edge boards that may be too large to go through your planer. Three wings make a fast, clean cut on your project material. This CNC router bit is carbide tipped. Specifications: Shank: 1/2" Cut Diameter: 2" Cut Length: 1/2"
B3
Reviewed in the United States on February 26, 2025
Works great. Flattened my bench top without issue using only a 2.3hp router.
Derek H.
Reviewed in the United States on February 23, 2025
Best surfacing bit I've used so far with my router and sled set up.
Customer
Reviewed in the United States on August 1, 2024
Great bits from Whiteside smooth finish
Bruce Regittko
Reviewed in the United States on May 7, 2024
I cannot find anything bad to say about this bit. I use it in my Bosch router with a jig to flatten end grain cutting boards that I make. It works like a champ! After about a dozen boards, I can't detect and difference between the first board and the most recent. While a bit pricey, you get what you pay for and this well worth it.
M. Johnson
Reviewed in the United States on May 27, 2024
I bought this to surface end grain on walnut, cherry and maple and it works very well leaving a very smooth finish and no tear out.
Lloyd
Reviewed in the United States on December 6, 2024
The carbide teeth are quality and held up to a 1/4" pass to test it out. At 1/8" or less it's as of the your pushing air. Cuts very well and leaves a smooth cut surface.
john smith
Reviewed in the United States on April 2, 2024
this is perfect
Adam A.
Reviewed in the United States on August 20, 2019
The bit arrived quickly and was in good condition. The edges of the bit were all razor sharp and had plenty of that protective wax/rubber on it. I bought this bit exclusively for slab flattening and surfacing end grain cutting boards smooth with my router sled. Since this was the first one I’ve ever tried, I don’t have anything else to compare it to, but as with all of my Whiteside bits, I’m quite pleased with its performance. My router is a DeWalt DW-618 (2 1/4 HP) and it handled surfacing the stick with now issues at all. Taking passes and removing about 3/4” by about 1/8” deep per pass, this bit left the surface of an end grain hardwood cutting board perfectly flat and quite smooth, with no lines and minimal follow up sanding required. Whiteside bits have always performed well for me. They’re not inexpensive, but they’re not cheap either. You get what you pay for: a quality product. I would certainly recommend this product.
Recommended Products
