Your cart is empty.
Your cart is empty.4.2 out of 5 stars
- #107,360 in Industrial & Scientific (See Top 100 in Industrial & Scientific)
- #142 in 3D Printer Platforms
Product Description
christopher
Reviewed in the United States on February 2, 2024
I like the two surfaces to choose from. I didn't get to use it with the 3d printer because I stupidly got the wrong size but it makes a great surface for a 3d print pen which is how I've been using it and its great for that.
Carlos Mila
Reviewed in the United States on January 9, 2024
Falta 1mm a cada lado de la cama
Kindle Customer
Reviewed in the United States on January 14, 2024
I've been printing on blue painter's tape for years. I had seen these on-line but didn't really understand what a change this would make. A friend clued me in to give it a try. Installation was easy. Adhesion issues almost completely resolved, maybe one or two have come loose, of hundreds. Removing prints is much, much easier. Often, if the bed has cooled, the part is loose when I come back to the printer. If not, removing the build plate, fanning it in the air for about 20 seconds to cool it a little, then flexing it a couple of times and the print pops off. I've never had difficulty removing a print since using this, yet they stick remarkably well when printing. (bed heat required - 45 to 50 C for PLA seems to be enough.)Tape, hair spray and Elmer's for adhesion are in my past. Also spatulas and water-soaking are no longer needed for removing prints. I wish I'd tumbled to this years ago.
Tony R.
Reviewed in the United States on April 7, 2024
I always have issues with glass after using a bit. But this is one fantastic magnetic bed! One side prints a smooth bottom and the other a very pleasing pattern! If you're looking for a bed upgrade id highly recommend this one!
cbird
Reviewed in the United States on April 3, 2024
Ok, I'm fairly new to this but I really like this. Adhesion is good and the finished item pops off without having to muscle it off.
D. E. Geake
Reviewed in the United States on October 9, 2023
The 310 x 310 size is perfect for my Longer LK5 Pro. Removes easily from the magnetic surface to remove prints from the build plate. I needed to shim my bed with paper to get it perfectly flat. (Low spot in the center.) This is an issue with my bed, not the Tofelf surface. Adheres well to the bed without any slipping, even with the paper shims. Easy to install. Very good print adhesion. Finished prints are easily removed by flexing the surface after removal.
Customer
Reviewed in the United States on October 3, 2023
Getting easy good first layers without trying hard, then popping the part off with ease, it's perfect. Way better than struggling with glass beds.
Customer
Reviewed in the United States on October 16, 2023
The media could not be loaded.
Recommended Products