Your cart is empty.
Your cart is empty.Product Description
Mainiac
Reviewed in the United States on January 29, 2025
So far so good! using this to make kitchen cabinet doors from Hickory. Hickory is one of the hardest domestic hardwoods but so far this bit has held up well.
Ronnie Beadler
Reviewed in the United States on January 2, 2025
Poor quality control. Do not buy. The tenon was too wide for the mortise.
JoeJoe
Reviewed in the United States on January 18, 2025
Works great, would recommend!
Martin Brubaker
Reviewed in the United States on August 28, 2024
I used this bit to make some poplar door fronts. It worked very well as setup. I didn't need to add or remove shims. I did get a little tearout on the stiles. I was kind expecting that so i made them a little wider, took a 1/16" off on the table saw and then put them through the router and it cleaned it up great.
Brian Allen
Reviewed in the United States on December 26, 2024
Did good job for the price. I consider it a good value
Steve Wellen
Reviewed in the United States on December 25, 2024
Christmas gift
RealAccount
Reviewed in the United States on November 2, 2024
I decided to make shaker panel doors to replace all the fronts on my kitchen cabinets. I first bought a different router set that was a total disaster.This Raised Panel Router Bit has been great. I cut 24 panels for the door fronts and the bit is still sharp. I'm happy with this purchase.
John P.
Reviewed in the United States on September 22, 2022
Unfortunately there are some quality control and design issues which prevent these router bits from being better. The first set I ordered (see first picture) had one bit with a cross-threaded top nut. That is obviously very dangerous, so I sent it back and received a replacement. The second set of bits had both top nuts loose, so that should be checked before using the bits. The design issue also relates to the nuts, which should be the nylon-insert "lock" nuts rather than the standard nuts provided. When the bit is spinning at 20K RPM, that but needs to stay put!That said, the actual cutting edges are sharp and provided a decent result on the pine I tried. They do provide spacers to adjust the cut if needed. So if the manufacturer would just pay more attention to quality control and replace the standard top nut with a nylon-insert locking nut, these would be a good buy. As they are now, though, I can't fully recommend them.
Recommended Products
$21.95
$ 10 .99 $10.99
$141.75
$ 69 .99 $69.99
$135.00
$ 62 .99 $62.99