Your cart is empty.
Your cart is empty. ✔ Product Name: Hex Coupling Nut
✔Size :M8x25mm
✔Material: Female thread,304 stainless steel material.
✔Length: 25mm / 0.98"
✔Hex Width: 13mm / 0.51"
✔Thread Size: M8 - 1.25
✔Package Content: 2 pcs x Hex Coupling Nut
Claudia Lambaren
Reviewed in the United States on February 16, 2024
It's a good size, but did not work for my application
Paul Bendele
Reviewed in the United States on November 20, 2024
Was described. Good quality
Bill
Reviewed in the United States on May 18, 2021
Good wuality stainless steel. Used these on my 2001 Yamaha Royal Star Venture to replace the stock seat hold down nuts. These are much easier to take off and put on than the original nuts. The longer length makes them ideal
DDGood
Reviewed in the United States on February 2, 2021
Perfect replacement for lost bolts for my Thule 460 podium roof rack mounts. Appear to be good quality.
Redtail
Reviewed in the United States on November 17, 2021
The adjustable rearsets I put on my Suzuki Bandit 1200 didn't play well with the OEM rear brake master cylinder. The rear of the brake lever was too low to fully compress the cylinder piston. I cut one of these connectors roughly in half and used it to connect the cylinder's threaded piston shaft to a short piece of all thread (an appropriately sized bolt with the head cut off). The all thread then screwed into the brake lever. It works perfectly. The connection has stayed tight through several thousand miles, and the rear brake works like it is supposed to.
Fess
Reviewed in the United States on February 11, 2020
On a scooter, the mirrors were too low and made with this thread size. By using these and M* x 1.25 pitch allthread, I was able to raise them both up so they are not blocked by my shoulders. Much safer riding and solid connections.
VMillan
Reviewed in the United States on November 19, 2020
I was trying to make a door handle fit our new barn door. The door is in a narrow space, and I ended up getting 2 of the same handles (one for each side) but the handles themselves stuck out too much. The bases for the handles were flush with recessed holes to grab, but the “nut” for the bolts was part of the actual handles. I bought these to put in drilled holes in the door and screwed the bases of the handles to these for a nice “sandwich” of base, wood, base so I could use the bases as handles.
Anonymous
Reviewed in the United States on November 14, 2019
Good fit and decent quality. Good buy, especially for the quick shipment.
Recommended Products
