Your cart is empty.
Your cart is empty. Features:
UI: 220V, ITH: 25A, 3 Position, 8 Terminals.
Material: flame-retardant PC fuel, good insulation performance, high temperature resistance; using high-quality copper parts, good electrical conductivity; using silver alloy contacts, low resistivity, no arc.
Appearance: fine workmanship, flexible handle, small size, and long service life.
Scope of application: It is widely used as circuit control switch, test equipment switch, motor control switch and main control switch, signal transmission switch or transfer switch of electric welding machinery and other equipment.
Note: Before ordering, please pay attention to the voltage level to ensure that the universal switch can work successfully after purchase.
Specifications:
Material: Plastic.
Color: White.
UI: 220V, ITH: 25A, 3 Position, 8 Terminals.
Model: LW26-25A.
Package included:
1 x changeover switch. 4 x mounting screws.
Fazeed R.
Reviewed in the United States on February 27, 2025
It was able to make my 220v single phase motor into a forward and reverse direction by a flip of a switch
Emanuel
Reviewed in the United States on August 20, 2024
Es mas chico que lo que aparenta en la foto, tuve espacio para la conexión y funcionó bien
Nelson F. Molina
Reviewed in the United States on August 16, 2024
hace el trabajo
josh Williams
Reviewed in the United States on October 14, 2024
Works well. The box is a bit tight though
Sir_Kibble
Reviewed in the United States on June 5, 2022
Used it to toggle my solar panel setup between disconnect, panels in series, and panels in parallel. I'm thankful they have so much room in the box as they anticipated it getting stuffed full of thick cabling. I had to make 2 jumps inside the box and while it was tight, everything fit and didn't flex the box.The only reason I docked a star was because the sealing gasket it comes with is pretty lousy. Recommend you make your own if you plan on using it outside.
Dena Meier
Reviewed in the United States on December 16, 2022
OK switch. Terminals are too small. Terminal lugs for 8 or 6 AWG wire will not fit. Have to fabricate custom terminal adapters out of flat copper bar stock to use this. Marginal switch contact resistance. Intermittent contact resistance quality. Box is too small for the 8 or 6 AWG wire. 32 Amp requires 8 AWG wire at least. Not so good for original intended use - select of 25 amp circuit - between generator or AC inverter. May use elsewhere for lower current circuit switching.
Recommended Products
