Your cart is empty.
Your cart is empty.Product Description
Carbide Square End Mill for Steels, HRC 55 Deg, 4 Flute, AlTiN Coating End Mill Bits for Milling Alloy Steels, Hardened Steel, Metal & More
Jim bo
Reviewed in the United States on January 29, 2025
Will buy. A Gain
Blake
Reviewed in the United States on September 25, 2024
Machined 303 stainless very well. I am pleased with the quality especially for how much they cost.
travels
Reviewed in the United States on September 19, 2024
I used it to cut a keyway
Jason Owens
Reviewed in the United States on August 20, 2024
I bought this to cut out a broken tap in a part I didn't want to scrap. It worked great for that, chewed through it like a hot knife through butter. However, it chipped on me part way through (but I powered through the tap anyway.).It was probably my fault though, being an amateur machinist. Maybe rpm was too slow??
Zack L.
Reviewed in the United States on June 19, 2024
First off, I'm not a mill guy. I can't speak on the true quality or longevity since I have no real milling experience. However, when I used it in my palm router to mill out 2 1" holes 3/4" deep it did an awesome job. I also used it to shave a steel rod down to the diameter I needed and again it performed well and is still very sharp. I would absolutely buy one if these again if this one dulls out.
Dual-500
Reviewed in the United States on June 16, 2024
These are good cutters. They will plunge cut into mild steel without any chatter or problems and are sharp so they cut nice and smooth. I use them most times dry.
matthew
Reviewed in the United States on March 3, 2024
since i had to buy a 5 pack i have been using these as my go-to for some random tasks thinking I could break one here or there, but im still on the first and impressed with the quality of them.
Oldshoes
Reviewed in the United States on February 18, 2024
The media could not be loaded.
Recommended Products