Your cart is empty.
Your cart is empty.
Measuring range: 100psi pressure
Accuracy: ±1.0%FS
Output signal: 0.5-4.5V,
Supply voltage: 5-16VDC
Operating temperature: -40～105℃
Compensation temperature: -20～80℃
Operating current: ≤3mA
Temperature drift (zero&sensitivity): ≤±0.03%FS/℃
Long-term stability: ≤±0.2%FS/year
Response time: ≤3ms
Overload pressure: 150%FS
Burst pressure: 300%FS
Cycle life: 500,000 times
Sensor core: Al2O3-96% ceramic sensor
Pressure medium: Non-corrosive liquid or gas
Pressure connection: 1/8”NPT,
Electrical connection: Packard connection
Housing material: 316 Stainless Steel
Protection class: IP65
Explosion-proof class: ExiaⅡCT6
Weight: ≈0.080kg
Electromagnetism Compatibility :EN50081-1; EN50082-2; IEC61000-4-3
FixitagainTim
Reviewed in the United States on March 7, 2025
Works great with haltech
Mac
Reviewed in the United States on February 6, 2025
No pressure report on and gauge all wires and connection made. Just no readings. I wouldn’t recommend this product. Disappointing. Stopped the oil leak……
RT
Reviewed in the United States on September 8, 2024
I run an Autometer 0-100 psi fuel pressure gauge on my 7.3 PowerStroke. The Autometer sending unit has failed consistently every two years. They want $150+ for a replacement sending unit. So far, replacing this sending unit and the oil pressure sending unit for my Autometer oil pressure gauge has been the single most expensive repair item on this whole truck. In fact, fuel, tires, and batteries are the only things I've spent more on and at least you expect those to be consumable items...This sending unit is identical to the genuine Autometer one and is a fraction of the cost. It could go out every six months and I'd still be money ahead.
Jason
Reviewed in the United States on September 4, 2024
I used this in a DIY project with an ESP32 to measure the pressure of a pool filter in real time. The output voltage can go above 3.3volts, however for my application it will never happen (barring something catastrophic). The sensor worked just as it was supposed to.
Russell A Haring
Reviewed in the United States on March 8, 2024
Sensor seems to be accurate to within 1PSI of a gage. The only bad thing was that the pigtail had a broken wire in it and I had to repair it.
shadetree
Reviewed in the United States on December 2, 2024
Easy installation and worked perfectly as a fuel pressure sensor.
Richard
Reviewed in the United States on December 2, 2024
i made the mistake of buying this sensor when i needed a 5v max sensor supply which caused my signal in my tuning software to make the gauge bounce around iradically.if your hooking it up to a analog gauge it may not do that because your pulling an actual 12v signal from battery to make it work but for tuning purposes don’t use this one if your wiring it into a harness.if your looking for a fuel pressure sensor with low voltage get something else on this platform or buy an AEM. make sure it’s 5vdc MAX supply and a 0-5vdc signal.
Christopher
Reviewed in the United States on December 15, 2024
It didnt work out the box please stay away from this junk
Recommended Products
$14.89
$ 7 .99 $7.99