Your cart is empty.
Your cart is empty.We stock a wide variety of fasteners ideal for many applications around the home, farm, business, automotive, and in industry. Most of our fasteners have a light zinc plating over steel giving a more rust resistant finish. We also sell coated and stainless products for additional rust resistance. We stock many grades of fasteners ranging from low carbon steel on up to hardened, heat treated steel. Not all fasteners are applicable for all applications so be certain to test thoroughly and get the opinion of a licensed builder or certified building or structural engineer before relying on these fasteners for any situations where failure would result in damage to property or person.
Hiknful1
Reviewed in the United States on July 26, 2024
Cheap steel - stripped out the outside end 1st time. Garbage. And yes, I used the correct socket.Should be a zero (0) rating.
RAD
Reviewed in the United States on July 19, 2021
I lost my wing nuts after Hurricane Sally. It turned out that there were two different brands of hanger bolts for the shutters. The replacement wing nuts only fit on one brand. I ordered these just before Hurricane Elsa. They arrived in time and I replaced the old bolts. Now they work just fine.
gppoveda
Reviewed in the United States on September 8, 2020
Works well, but pricey
Harry K. Robinson, Appraising
Reviewed in the United States on July 23, 2020
I'm in So. Florida so I'm concerned about corrosion but for the price, I'm not that concerned. Cheap enough to replace.
Eliot Underhill
Reviewed in the United States on July 22, 2020
It was awesome to be able to find these and receive them before the seasonal rush. I’m hoping that they’re not needed at all this season, but we’re ready.
mike
Reviewed in the United States on June 3, 2020
storm shutters
Brad Kuhn
Reviewed in the United States on May 24, 2020
Hurricane panel anchors! Work great!!
M. Dameron
Reviewed in the United States on August 7, 2018
Used for storm shutters on concrete block walls. Worked great! They suggested 7/32" bit. I tried 3/16" ( more common for impact drivers). Worked better on concrete block. The small hex head mentioned in description did drive them in most of the time pretty well. Might need double nuts jammed together, instead, to drive them in difficult walls.
Recommended Products
