Your cart is empty.
Your cart is empty.Zero start 3100025 Freeze Plug Engine Block Heater for Kubota, 35mm Diameter , CSA Approved , 120 Volts , 400 Watts. Kubota D102, D1302, D1403, D1703, D1803, D2203, D2403 (3 cyl. ), S2800 (6 cyl. ), F2803 (5 cyl. ), V1702, V1703, V1902, V1903, V2003, V2003T, V2203 (4 cyl. )
Heather
Reviewed in the United States on January 6, 2025
Had a V1903 put in the 2 clock position plugged in come back check on it and nothing checked with ohm meter it's a open circuit checked cord all okay on cord why element burnt up? Loosened plug it leaks antifreeze and I did run engine before plugging in
Sequoia
Reviewed in the United States on January 21, 2025
The production looks fine but doesn't fit my equipment even if it was listed in the description. The most important is i'm not able to return...
Tiny
Reviewed in the United States on January 1, 2025
Put on a 4 cyl kubota that is 100% exposed to the elements on a sweeper truck. 20 degrees out and it starts right up....Just buy it
Jacob B.
Reviewed in the United States on December 10, 2024
Fit a bobcat 773 just fine, it didn't tighten up as tight as I'd expect but it didn't leak was pretty easy to install
Gil Rand
Reviewed in Canada on March 6, 2023
The block heater is fine and I'm sure it would work as expected. Unfortunately I bought this for a 742B Bobcat Skid steer loader with a V1702 Kubota engine and found out later that because of the position of the engine it would be difficult if not impossible to install. Evidently there is a metal plate between the engine and pump that prohibits installation in the rear of the engine head. I did not bother to return this item as I will likely be able to use it elsewhere if i can find it when I need it. There is a frost plug block heater, for the side of the head, available from Bobcat that will work and does not involve engine removal or modifications.
Marc
Reviewed in the United States on January 30, 2022
This won’t fit unless you want to pull your engine to install it. The proper heater needs to be a kabota heater with a sleeve to keep the heater away from the block. Trust what I tell you!!!!!!! I ordered it and I’m sitting here -30 in Minnesota with a skid loader with no coolant in it and no where to get the proper heater. Can you say fun?
tnwenger4450
Reviewed in the United States on January 27, 2022
Had to get a different o ring to seal the heater in a Bobcat S175 with a Kabota V2203 engine.
A
Reviewed in the United States on December 23, 2019
Perfect fit and works as expected.
Lounar
Reviewed in the United States on November 1, 2015
Company was very good in confirming the proper model and even telling me where to install this as I thought it went into the block but actually goes into the head. It has been in 2 mos now and not leaked a drop.
Recommended Products
