Shopping Cart

Your cart is empty.

Your cart is empty.

YG-1 - F4423 F4 Series Vanadium Alloy HSS Spiral Flute Tap, Steam Oxide, Round Shank with Square End, Bottoming Chamfer, 1/4'-28 Thread Size, H3 Tolerance

4.5 (8) Write Review
Free shipping on orders over $29.99

$9.15

$ 4 .99 $4.99

In Stock
  • High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
  • Black oxide treatment adds lubricity and creates small pockets on the surface of the tool that act to hold coolant near the cutting edge
  • Round shanks allow use with a wide variety of toolholding systems
  • When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
  • 0.625-inches thread length


YG-1 F4 series vanadium alloy HSS spiral flute tap for multi-purpose. High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance. Black oxide treatment adds lubricity and creates small pockets on the surface of the tool that act to hold coolant near the cutting edge. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. 0.625-inches thread length. Applications: Good for steel castings and forgings/heat-treatable alloy steels, free machining stainless steel, heat and corrosion-resistant stainless steel/valve stainless steel, aluminum alloy castings. Excellent for low carbon/free machining carbon steel, medium to high carbon steel.


Jason
Reviewed in the United States on October 21, 2024
Taps arrived dull and did not cut.
Gary S
Reviewed in the United States on July 1, 2023
Where have you been all my life?? Whereas standard taps leave debris in the flutes, these guys eject the cuttings in a couple of fine coils as you drive the tap. It is much easier to drive the tap straight through without stopping to clear it. No fuss - no muss!
James
Reviewed in the United States on February 5, 2023
It sure did a nice job power tapping on a Bridgeport in 0.5” 7075 aluminum. No issue at all.
J Lloyd Hatfield
Reviewed in the United States on June 6, 2022
Great tool
Customer
Reviewed in the United States on January 1, 2022
Very sharp, cut threads like butter.
Mako Sather
Reviewed in the United States on April 25, 2022
A quality Tap, cut threads as advertised.Worked well for my need.
3531Anonymous654
Reviewed in the United States on December 9, 2021
Easy cutting and beautiful chip extraction. These are sharp, good quality taps.
John Ragozzino
Reviewed in the United States on July 5, 2016
Threads like butter, but it took 3 orders to get the right one.