Your cart is empty.
Your cart is empty.
How to use our products:
First Step
Strip the wire according to the specified length.
Second Step
Dismantle the orange operation handle straight and plug the wire into the hole.
Third Sted
lower the handle.
Problems in our lives:
Because the electrical tape, the wiring cap and other connections are prone to aging,
falling off, poor insulation performance, etc., the safety hazard is formed, which may
cause personal injury such as electric shock or a short circuit of the wire to cause a
fire. In addition, as the use of home appliances increases, the power load increases, such
as poor contact at the wire connection (excessive resistance at the connection), and large
resistance and large current cause heat increase, which will be a huge safety hazard.
The XHF connector completely avoids the above-mentioned safety hazards caused by poor
connection; our connector uses ROHS-compliant materials and is environmentally friendly;
the shell is made of flame-retardant transparent PC, nylon PA66, and the conductor is
tinned with pure copper. Small, low electrical loss, imported stainless steel circlip, and durable, reusable.
Doc
Reviewed in the United States on September 19, 2024
The kit arrived quickly and in perfect condition. On inital trial, I did not realize that you had to force the locking lever all the way to vertical, so I did not raise the lever all the way up thinking it did not go that far, which was causing a loose hold on the wires. I thought I was going to break it the first time I tried lifting the lever all the way up but pushed on until it did and my connections now hold very well. This is not mentioned anywhere I could find but I figured it out looking at one of the photos showing one in the full vertical position. The force needed to raise the lever all the way to vertical is pretty high at first , but they loosen up a bit after first time. So, I believe complaints of these not holding very well should retry using them and keep in mind they require using whatever force needed to get the levers to work properly.
Black TOMATO
Reviewed in the United States on July 23, 2024
Just opening the box and feeling these out, these seem very high quality. Ive just received the 81pcs set. They have very firm levers, both on the open phase and the snap close. Absolutely no slop & very crisp. Theres no possibility for that Wago problem where the lever pops back open as your stuffing the lever nut back into the electric box. The one downside of this thick build, it that these are at least twice as "tall" as Wago, so theres more space taken up by far. I recommend these where applicable.
Gerald P
Reviewed in the United States on May 30, 2024
These connectors are awesome they save a lot of time! Make a mistake no problem, I will continue to use these.
Mark
Reviewed in the United States on March 30, 2024
Good product. Easy to use
Chris F.
Reviewed in the United States on December 25, 2024
I picked these up to help me do mock ups of LED ribbon lighting installations. They’re very modular, so working with them is kind of like electrical legos. If I need to add another ribbon, I can use a larger connector and vice versa. The connections are solid and easy to make.Very handy so far…will see how they do in the long run.
MrB
Reviewed in the United States on June 25, 2023
Broke several wires when removing wire nuts and was grateful to have this product to save the day. Because the wires were short it was a challenge getting the wires seated properly so that the wire clips firmly held the wires - but once in place they are there to stay.THANK YOU for this excellent product.Note to new users - I thought my products were defective because I "couldn't get them to hold the wires." I didn't realize how firmly I needed to pull the levers to fully open them - they need to be at 90 degrees to holder or the wire won't catch. Once opened fully, the wires slip right in and hold beautifully once the level is firmly pressed back into place.
WestCoastJJ
Reviewed in the United States on December 23, 2022
I like these better than WAGO nuts which tend to pop open when you push them back into the box, requiring electrical tape around them to ensure they stay closed. These snap closed tightly and stay closed. Miles ahead of twist type wire nuts also, of course. And great to marry stranded with regular wires, as well as wires of different diameters.
Mike T
Reviewed in the United States on July 28, 2020
Very convenient , easier to use then wire nuts. The latches have a tendency to open when packing the junction box . I recommend wrapping the latches with electrical tape to keep them from opening!
Recommended Products
